Roper RAX4232KQ, RAS8445KQ, RAS8244LQ, RAS8244KQ, RAS7233KQ Dimension Guide
...
closet door
closet door
0"*
0"*
17"
48 sq. in.
14"
max.
4"
min.
24 sq. in.
1" min.
3"
3"
24 sq. in.
48 sq. in.
* Additional clearances for wall, door and floor moldings may be required.
PRODUCT MODEL NUMBERS REQUIREMENTS
RECESSED AREA AND CLOSET INSTALLATION
DRAIN SYSTEM OPTIONS
RAB2121K
RAS6233K
RAS8244K
RAS8445K
RAX4232K
RAX7244K
Electrical: 120-volt, 60-Hz, AC-only,
15- or 20-amp. electrical supply. A time-delay fuse
or circuit breaker and separate circuit is
recommended.
Closet confined area
front view
front view
If a closet door is installed: The minimum unobstructed air openings are
required. Louvered doors with equivalent air openings are acceptable.
side view
Recessed
area
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
1. Laundry tub or utility sink
drain system:
Needs a 20-gallon laundry tub.
2. Floor drain system:
3. Standpipe drain system:
Needs a two-inch minimum diameter standpipe with minimum carry-away
capacity of 17 gallons per minute. A 2" dia. to 1" dia. standpipe adapter, Part No.
3363920, must be used with 1" dia. drain systems.
Top of
standpipe
must be at
least 39
inches high
and no
higher than
96 inches
**
from
bottom of
washer.
Floor standpipe
drain
Wall standpipe drain
Top of tub must be at
least 34 inches high
and no higher than
96 inches from
bottom of washer.
34"
34"
Top of
standpipe
must be
at least 39
inches
high and
no higher
than 96
inches
**
from
bottom of
washer.
Hot and
cold water
faucets
Requires a
siphon break,
Part No.
285320. Siphon
break must be
above highwater level in
washer, at least
28 inches from
bottom of
washer.
Additional drain
hose will be
needed.
28"
min.
**If the drain height is greater than 96 inches, a sump pump system must be used.
Level floor: Maximum slope
under entire
washer — 1 inch.
To use drain hose shipped with
washer, standpipe, laundry tub or
utility sink should be within 46 inches
of the washer drain connector.
Grounded electrical
outlet is required
within 5 feet of upper
right corner of washer
cabinet.
Washer is 24" or 27" wide,
depending on model.
Hot and cold water
faucets: Should be
within 3-1/2 feet of upper
right hand corner of
washer cabinet. Provide
water pressure 5-100 psi.
Support: Floor must be
sturdy enough to support
washer weight (with
water) of 315 pounds.
5"
8"
washer
drain
connector
Ref. 3952817 Rev. B
11-21-02
Washer
®
Loading...