Roper 30” ElectricBuilt-in Glass Cooktop Installation Instructions Manual

30” Electric
Built-in
Glass Cooktop

ROPER

.

INIPORTANT:
Installer: Leave Installation Instructions with the Homeowner.
Homeowner: Keep Installation Instructions for future reference.
Save Installation Instructions for local electrical inspect013 use.

Before you start...

PIi iper

1nstallat10n

1s your
re:,ponstitity. Make sure you have
ev-:rythmg necessary

ior COneCt

mn!,tallatlon. It is the responslblhty
of he mstaller to comply with
m! tallatlon clearances shown.

Grounded electrical supply
1s :equred. See ‘Electrical
re(.urements’.

Important:

Observe

all governing codes and
ordinances. Failure to meet codes
and ordinances could lead to fire
or electrical shock.

Th? clearances specified are for
coubustlble wak and materials
th:,t have a densitv of 20 or
mere pounds per cubic foot. No
ev;luatlon of clearances has been
made for mstallations adjacent to
ma:erials that are less that 20
pounds per c&c foot or to plastic
t&s and sheetmg.

New installations -Follow
rec’xnmended timenslons shown.

Replacement installations ­Colmtertop openmg must be
wltnin dunenslons shown. Be sure
tha; front edge of cooktop is at
least l-l/Z’ back from front edge
of c ountenop.

If clbmet has a drawer. a 4’ depth
clezmce from the countertop to
the top of the drawer (or other
obsimction in the base cabmet)
1s rqued

!

Personal Injury Hazard

Cabinet storage above the
cooking surface should be
avoided. If cabinets are
alreadv installed. reduce the
hazard of reaching over a
heated cooking surface by
installing a range hood.

The range hood should extend
a minimum of 5 inches out
from the bottom of the cabinets

Reaching over a heated
cooking stuface could result
in a serious bum.

­I

NOTE: )

It is the customer’s
responsibility:

m To contact a qualified

electrical installer.

m To assure that the electrical

installation is adequate
and in conformance with
National Electrical Code
ANSI/NFPA 70 - latest
edition, and all local codes
and ordinances.

Check locatlon where cooktop wLLl
be mstalled. The locatlon should be
away from strong draft areas, such
as wmdows, doors and strong
heatmg vents or fans. The cooktop
should be located for convement
use m the lotchen.

3o’rmn base cabmet IS
reamred. IJ cabinet has a drawer.

_

a 3-112’ depth clearance from the’
countertop to the top of the drawer
(or otner otxtructlonj m nase
cabmet is requred.

For

new installations:

For

replacement

installations:

Tools needed
for installation:

PANEL A