Roper 2323 Owner's Manual

Lift-Up Cooktop

-

Oven Signal Light
Oven Light Button
Backguard Light Button
Oven Thermostat
Infinite Cooktop Unit
Controls
Clock and I-Hour Timer
Delay StarllTlmed Oven
Controls

FEATURES

9. Oven Selector

10. Cooktop Signal Light

11. Plug-in Cooktop Units

12. Removable Black Glass
Oven Door

13. Storage Drawer

14. Leg levelers

ELECTRIC RANGE

MODEL 2323

OPERATING GUIDE

CLOCK
To sel:

Push in and lurn the clock face

1

knob to set Ihe correct time of
day

2 Turn the clock face knob,

wlthout pushing III lo reset the
timer hand to OFF

TIMER

The lamer may be se1 for any amount of time from 1 to 60 minutes. Turn the
timer knob, wllhout pushing In, lo set the timer hand to the desired time.
When time is up, a slgnal
timer is only a reminder and will nol control the oven.

COOKTOP UNITS
See your Use and Care Guide for delails.

OVEN/BROILER
To use the bake and broil oven, set the Selector for the type of cooklng, then

sel the Thermostat for the desired temperature or for BROIL (BR). See your

Use and Care Guide for details

Preheat: Use lo preheat the oven quickly. Both upper and lower elements

will heat. Be sure to reset Ihe Selector lo BAKE before putting
food into the oven. If Ihe Selector is left on PREHEAT, the
food will burn on top.

Bake: Use for baking, roasting and warmlng Only the bottom element WI/I

heat.

Tlmed Oven: Use for a Delay Start Tlmed Oven operation (see next page)

Only the bottom element will heat.

Broil: Use for broiling or rollssIng Only the upper element WIII heat.

will

buzz until you reset the timer hand IO OFF. The

Part No. 324122

DELAY START/TIMED OVEN
This feature lets you set the clock to control the oven and leaves you free lo

do other things. The oven can be set to turn on at the start time, heat to the
set temperature, hold that temperature until the stop time is reached, then
turn off.

To set:
1, Set the START TIME (push in and turn)

NOTE: This step is necessary only for a delayed start operation. The

oven will start at once as long as the start time is the same as the
tlme of day on the clock.

2. Set STOP TIME (push in and turn).

3. Set SELECTOR to TIMED OVEN.

4. Set THERMOSTAT to the desired temperature.

5. When done, turn SELECTOR and THERMOSTAT to OFF.
NOTE: Never let food sit for more than 4 hours before cooking starts,

when you set your oven for a delayed start. Room temperature

promotes the growth of harmful bacteria.

SIGNAL LIGHTS
Cooktop: will glow whenever one or more of the cooktop elements IS turned

on.

Oven: WIII glow when the oven IS turned on. When the oven has reached the

set temperature, Ihe light will go off, then cycle on and off with the

oven to show the temperature IS being mamtatned.

REPLACING THE BACKGUARD LIGHT
Do not touch the bulb when hot, with wet hands, or wipe light area witl

wet cloth. Unplug or disconnect the electrical supply to range befon
removing.

Remove the control and clock knobs. Remove both backguard screws, on’
on each side. Insert a dull bladed knife under Ihe bottom edge of the glas
and pry outward. The glass retatner will rotate outward and release thl
glass Remove the bulb and replace with one of the same length and wal
tage. With the retainer rotated out, push glass back into place. Replace the
screws and knobs.

OPTIONAL KITS
Opttonal Oven Rotisserie Kit No. 100-6504 and Gnddle Kit No. 100-6601

are available from your authorized Roper dealer.