Room & Board Portica Canopy Assembly Instruction

Campo Bed Assembly Instructions

Lists of parts: 1 top shor t r ail (with hole to receive

bolts & 2 wood bullets)
1 bottom shor t r ail (with hole to receive

bolts & 2 wood bullets)
2 side long rails (with metal insert)
10 wood slats

Hardware: 4-3 ?” inch threaded stud

4- nuts
4- cur ved washer
8- screws

Tools: Wrench (provided)

Screw driver

Directions: 1. Take the 2 side long rails and screw the 3 ?” threaded stud into the insert

until it stops. Put the nut 3 to 6 turns onto the end of the threaded stud.
Take 1 of the side rails and connect to the top short rail.

2. Slide the top shor t r ail over the nut and into the mating holes for the bullets
on the side long rail.

3. Slide the cur ved washer into the large hole , with the curve of the washer
against the cur ve of the round hole.Tighten the nut with wrench (provided).

4. Slide the bottom shor t r ail over the nut and into the mating holes for the
bullets on the side long rail.

5. Slide the cur ved washer into the large hole , with the curve of the washer
against the cur ve of the round hole.Tighten the nut with wrench (provided).

6. Take the other side long rail and assemble to the top shor t r ail and bottom
shor t r ail in the same manner.

7.At this point, the bed is free standing.With a screwdriver, install the 2 screws
per corner bracket into the corner metal br acket (Cor ner metal br acket is
pre-attached to the top shor t r ail and bottom short rail).

8. Inser t the 10 wood slats into the slots provided in the side long rails.

12/17/07