Room & Board Pogo Assembly Instruction

Hudson Bed Assembly Instructions

List of parts: 1 - headboard

1 - footboard
2 - two drawer platforms
12 - slats

Hardware: 4 - screws

Tools needed: Rubber mallet

Phillips screwdriver

Directions: 1. Place the two drawers sections side by side on the floor

near desired placement.

2. Attach footboard with the three metal brackets to end
of platforms inser ting brackets into drawer brackets.

3. Push down on footboard to insure it interlocks.

4. Use rubber mallet to tap into place, insuring tight fit.

headboard

footboard

5. Attach headboard in the same manner as footboard.

6. Insert a screw into the pocket holes in each of the four
corners of the bed. Tighten.

7. Insert slats into slots in side rails.

8. Place mattress on slats.

Tip: Wood naturally expands and contracts causing bed connections to

loosen over time. This process is a natural characteristic of wood. Tighten
hardware occasionally to restore the bed to original stability.