Room & Board Pisa Shelves Assembly Instruction

ASSEMBLY INSTRUCTIONS: PISA

List of parts

1 – right leg

1 – left leg

3

⁄16" shelf

1 – 6

9

⁄16" shelf

1 – 7

1

⁄8" shelf

1 – 9

5

1 – 10

1 – 12

⁄8" shelf

3

⁄8" shelf

1 – 14" shelf

Hardware

2 – L-brackets

8 – 1¼ wood screws

12 – bolts

Tools needed

Phillips screwdriver

7

drill with

pencil

⁄64" bit

MADE IN North Dakota

Directions

1. Place right and left legs angle-side down on the floor with slots

facing in.

2. Inser t the largest shelf into the bottom slot of the right leg. The

back of the shelf (indicated by a small drilled hole) must face the

floor. Inser t bolt and tighten so that the shelf cannot fall out of

its slot but can still move freely within the slot.

3. Repeat step 2 for the remaining shelves from largest to smallest.

4. Attach the left leg to the left side of the shelves in the same

manner as the right leg.

5. Tighten all bolts. CAUTION: do not overtighten.

6. Position Pisa against the wall, and mark the wall at the top of

each leg immediately above each notch. Place the L-bracket

directly under the mark and screw into wall (see Figure 1).

Repeat with L-bracket for other leg.

7. Drill holes into the top of each leg corresponding with holes in

the L-brackets. Insert screws through the L-brackets and into

the legs.

Figure 1

800.301.9720 | roomandboard.com

6/27/13