Room & Board Montego Sun Bed Assembly Instruction
OPTIONAL CASTER INSTALLATION: LIND OTTOMAN
Caster Stem
Caster Stem
Stationary
Stationary
Legs
Legs
WasherWasher
T-nutT-nut
1. To begin, turn the ot toman over. With the ottoman
turned over, remove all stationary legs by turning them
counterclockwise until removed. Set aside stationary legs.
Caster
Caster
4. Slide the caster onto the caster stem. Using downward
pressure, as shown in the image above, push caster onto
caster stem until it snaps into place. Repeat with the
remaining casters.
2. Take a caster stem and a washer from the included
hardware kit. Inser t the caster stem into the washer, and
then into one of the remaining T-nuts. There will be four
(4) total for square ottomans or five (5) total for round
ottomans. Hand tighten the caster stem. Repeat this for
the remaining T-nuts.
5. Turn the ottoman upright and make sure all casters are
snapped down completely or ottoman may wobble.
3. Using a ½" wrench or ½" deep socket, snug down the
caster stem. Do this for all caster stems.
CAUTION
The included casters are intended for use on carpet or
rugs. Use care when rolling the ottoman across hard
surfaces — floor damage may occur as debris catches
underneath the caster.
6 /7/ 13
Loading...