Room & Board Moda Loft Assembly Instruction

assembly instructions: pogo bed

footboard

headboard

List of parts

1 – headboard

1 – footboard

2 – bed rails

1 – slat roll

Hardware

4 – wood dowels

8 – connector bolts

8 – metal collars

28 – wood screws for slat roll

Tools needed

ball end Allen wrench (provided)

DO NOT USE POWER TOOLS

MADE IN N ew Yo rk

B ARREL
N U T

Directions

1. Inser t a wood dowel into the middle hole of each trio of holes on both the headboard

and footboard. Screw a connector bolt into each of the barrel nuts, leaving four or five

threads exposed.

2. Align connector bolts with the holes on the end of a bedrail, slipping bolts through

pre-drilled holes in the bedrail. Repeat on other side. Make sure each bedrail is tight up

against the post.

3. Through the large hole in the side of the bedrail, slip one metal collar over each connec-

tor bolt. Use the ball-end allen wrench to start tightening each bolt, then switch to the

short end to finish tightening completely.

4. Unroll and lay the slatroll inside the bedrails equidistant from each end, with the webbing

facing up. With the 28 wood screws provided, attach the slats.

Cleaning

Mix a mild solution of gentle dishwashing liquid and water, apply to surface using a soft,

clean cloth, then dry all surfaces with a soft, dry cloth. NO ABRASIVES, SCOURING

PADS, STEEL WOOL, OR COARSE R AGS should be used to clean this fine furniture.

Replacement parts, including additional guardrails, may be obtained from any Room &

Board store.

Steps 1-3 : bedrail attachment

800.301.9720 | roomandboard.com

4/1/11

tip

Wood naturally expands and contracts causing bed connections to loosen over time. This
process is a natural characteristic of wood. Tighten hardware occasionally to restore the bed
to original stability.