Room & Board Jackson Assembly Instruction

Prairie Bed Assembly Instructions

List of parts: 1 - headboard

1 - footboard
2 - side rails
1 - slat roll
1 - center suppor t r ail (california king only)

Hardware: 4 - brass pins

Tools needed: phillips screwdriver

rubber mallet or hammer

Directions:

headboard

footboard

1. Hold headboard upright near its desired placement.

2. Allowing the side rail to rest on ground, lift one end of side rail into
headboard post by slipping shoulder screws of side rail into headboard
interlocking keyhole hardware. Note: the screw ends must be adjusted
properly.If they are too tight,the screw heads will not lock in place.If they
are too loose, the rails will move, creating squeaks and eventually weaken
the joint. To ensure your rail tension is correct, make sure the rail moves
down and locks when you tap it with a mallet.You should not be able to
twist the rails with your hands once they are in place.Tighten screws if
needed after assembly.

3. Attach footboard to both rails in the same manner as headboard.

4. Place the four brass pins in holes on slat support ledges.

5. California king only: Slide center suppor t into slots on headboard and
footboard.

6. Place slats on side rails with the two end slats hooking over the four pins
to prevent movement.

7. Place mattress on slats.

12/18/07