Rongta Technology AP02 User Manual

Working Temperature:-10ÿ—40ÿ

Working Humidity:20%—85%

Storing Temperature:-20ÿ—70ÿ

Storing Humidity:5%—95%

Hardware Name:170910

Hardware Version :C

Software Name:S1709

Software Version:1.0.0

X I A M E N R O N G T A TE C H N O L O G Y C O . , L T D .

3F-1/E Building,NO.195 Gaoqishe,Gaodian Village,Dianqian Street

Office,Huli District.

Website: www.rongtatech.com

Project Technical Parameter

CPU 1.4GHZ Quad-core

512MB

Storage

4GB Emmc

G S M 855 0( 3 1 .5±1.5d B m), G S M 1 9 0 0

WCDMA Band II(22.5±1.5dBm),WCDMA

Internet

BandV ( ±1.5dBm)

BT4.0 dual mode (< 0dBm)

17

2.4GWIFI b/g/n(<1777 dBm)

GPS

FCC Requirement
changes or modifications not expressly approved by the party
Responsible for compliance could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is
Subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can

radiate radio frequency energy, and if not installed and used
in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this

(28.5 1. 5dBm)

±

7

equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one
or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.

– Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. End user must follow the
specific operating instructions for satisfying RF exposure compliance.
This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.The device is designed to meet
the requirements for exposure to radio waves established by the Federal
Communications Commission (USA). These requirements set a SAR limit
of 1.6 W/kg averaged over one gram of tissue when properly worn on the
Body and set a SAR limit of 4.0 W/kg averaged over ten gram of tissue
when use in handheld. The highest SAR value reported under this standard
during product Certification for use when properly worn on the body
is 1.534W/kg and use in handheld is 1.959W/kg. For body operation, this
device has been tested and meets FCC RF exposure guidelines when used
with any accessory that contains no metal and that positions a minimum
of 5mm from the body. Use of other accessories may not ensure compliance
with FCC RF exposure guidelines.