Ronbow Shoji User Manual
SHOJI
Installation Sheet
25”/30’/36”
Model:
Note :
Step 1 :
Mounting ring
040425
040430
040436
For installing above counter sink.
DO NOT USE any adhesives with silicone.
Silicone will bond to the decorative finish
and cause permanent damage.
Position and drill a 1-3/4” hole for the
drain on the countertop. Place mounting
ring under the sink as shown on the
right
Mounting Ring Detail
Rubber
washer
Vertical viewHorizontial view
Bottom O-Ring
Drain Cap
Thick rubber
washer
Metal Nut
T
ailpiece
Thick rubber
washer
Metal Nut
Tailpiece
Pacific Rim Collection
Rubberw asher
Mounting Ring
Countertop
Drain
Mounting Ring
P-trap
Step 2 :
Step 3 :
Step 4 :
Drain assembly picture
Place a generous portion of plumbers’
putty under drain cap and insert whole
drain body inside the bowl and through
the countertop
(There may be a small beveled rubber
washer packaged with your drain, please
discard this and use plumbers’ putty instead)
From under the drain, insert the thick
rubber washer and screw on and tighten
the metal nut. Remove excess plumbers’
putty and attach p-trap to tailpiece
Secure top & back splash to cabinet by
using adhesive caulk
www.ronbow.com
Ronbow Corporation, All Rights Reserved.
SHOJI
Installation Sheet
25”/30’/36”
Model:
Note :
Step 1 :
Step 2 :
040425
040430
040436
For installing under counter sink with
counter top
Apply adhesive caulking around the
topside of rim near the edge, Carefully
raise sink in place, align, and press firmly
See Figure 1.
Attach 4 undermount-clips to hold
lavatory in place
See Figure 2.
Pacific Rim Collection
Figure 1.
Back Splash
Counter top
adhesive caulking
Figure 2.
Step 3 :
Figure 3.
Undermount Clip
adhesive caulking
Secure top & back splash to cabinet by
using adhesive caulk
See Figure 3.
www.ronbow.com
Ronbow Corporation, All Rights Reserved.
Loading...