Ronbow Rowena User Manual
ROWENA
Installation Sheet
24”/32”/36”
Vanity:
500030
500033
Drawer:
667025
667033
667037
For installing GLASS top:
Screw on chrome spacers (parts A, B, & C)
to leg support. Glass top is placed on top of
spacers.
For installing WOOD top:
Chrome spacers (parts A, B, & C) maybe used
but not necessary. Wood top may be placed
on spacers or may be glued to leg supports by
using silicone adhesives.
For installing STONE top:
Discard chrome spacers and use silicone
adhesive to secure top to leg support.
For installing towel bar (T):
Drill towel bar holders (part F) into each leg
support and insert towel bar (T). Use set screw
(part G) to tighten.
Contempo Collection
Note: Towel bar (T), bottom Drawer and Bottom Shelf
(S) are optional and it must be purchased separately.
Counter Top
Bottom Shelf (S)
For installing leg support:
Drill screws (parts D &E) into wall through
holes in leg supports. There should be 4 holes
per each leg support. Please make sure there
is proper support behind the wall in your drill
location. Dierent wall materials may require
dierent screw types. Please consult your local
hardware store.
For installing bottom shelf(s):
The bottom shelf rests on the bottom ledge of
the leg supports. No adhesives are necessary.
Installing Bottom Drawer
Step 1: Release the lever on each side, according to the
arrows and pull out drawer.
Step 2: screw to the side of the stand
h
h
www.ronbow.com
Ronbow Corporation, All Rights Reserved.
ROWENA
Installation Sheet
24”/32”/36”
Vanity:
Note :
Step 1 :
Step 2 :
500030
500033
Drawer:
667025
667033
667037
This is for installing Glass Sinktop
Screw in 4 countertop spacers into
1
the holes provided on top of the
cabinet
See Figure 1.
Position and set vanity top on cabinet
See Figure 1.
Contempo Collection
Figure 1.
1
Figure 2.
Drain Cap
Step 3 :
Step 4 :
Step 5 :
Place a generous portion of plumbers’
putty under drain cap and insert
whole drain body inside the bowl and
through the countertop.
(There may be a small beveled rubber
washer packaged with your drain, please
discard this and use plumbers’ putty instead)
See Figure 2.
From under the drain, insert the thick
rubber washer and screw on and
tighten the metal nut. Remove excess
plumbers’ putty
See Figure 3.
Attach p-trap to tailpiece.
Figure 3.
Drain
Drain Nut
Thick rubber
washer
Metal Nut
Tailpiece
Thick rubber
washer
www.ronbow.com
Tailpiece
P-trap
Ronbow Corporation, All Rights Reserved.
Loading...