
LED AnD MEtAL MEDICInE CABInEt
619623
MATERIALS NEEDED:
PHILIP SCREWDRIVER
STUD LOCATOR
LEVELING TOOL
INSTALLATION SHEET
MATERIAL PROVIDED:
(4)WOOD SCREWS
(4)MOUNTING HARDWARE
(2)GLASS SHELVES
(8)MOUNTING HARDWARE FOR SHELVES
ACCESSORIESMODEL: 618523
If your new medicine cabinet has a built-in led then follow the section below.
ALL WIRING SHOULD BE DONE BY A QUALIFIED LICENSED ELECTRICIAN.
WARNING: To reduce the risk of electrical shock, shut o power before wiring the cabinet.
CAUTION: Requires 120V 20AMP circuit.
CAUTION: This product must be connected to a grounded, metal permanent wiring system or an equipment-grounding
conductor must be run with the circuit conductors and connected to the equipment grounding terminal or lean on the product.
CAUTION: A LED option cabinet must be wired to a 20AMP GFI (ground fault interrupter) circuit breaker when used in
bathrooms and all other locations required by the national electric code.
Circuit Breaker
Black Black
20AMP CFI
White White
Ground
Wall Terminal
NOTE: locate the wire at the top of the cabinet. The qualified license electrician has the option to plug into a wall outlet, or hard
wire the cabinet by cutting the plug.
REV. OCT, 2013ronbow.comINSTALLATION GUIDE

LED AnD MEtAL MEDICInE CABInEt
619623
SURFACE MOUnt InStALLAtIOn
STEP 1:
metal medicine cabinet. Make sure cabinet has enough
clearance from faucet and ceiling.
Note: LED option (model 619623) see page 1 for electrical
connection.
See Figure 1.
Determine the ideal location of your new
INSTALLATION SHEET
Figure 1.
Minimum to Faucet
ACCESSORIESMODEL: 618523
Minimum to Ceiling
1”
1”
STEP 2: It is strongly recommended the cabinet is
mounted to studs with the wood screws provided.
anchors must be used, it must hold up to 80lbs.
Note: Maximum mounting distance for cabinet hardware is 16”
center to center.
If
See Figure 2.
STEP 3:
into the studs.
Note: The wood screw should have enough space from the
wall to mount the cabinet.
Drill the (2) wood screws that are provided
See Figure 3.
Figure 2.
Figure 3.
16”
Stud
Wall
1/8”
REV. OCT, 2013ronbow.comINSTALLATION GUIDE

LED AnD MEtAL MEDICInE CABInEt
619623
distance of the metal mounting hardware to the wood
screw on the wall from step 3.
See Figure 4.
STEP 5: Mount the cabinet to the wall by lining up the
metal mounting hardware to the wood screws on the
wall.
Note: Tighten wood screws to secure cabinet. Line up the
screw with the round part of the keyhole hardware and drop
the hardware into place.
INSTALLATION SHEET
Figure 4.STEP 4: Slide hardware on the top rail. Match the
Figure 5.
ACCESSORIESMODEL: 618523
Slide
Screw in wall
See Figure 5.
STEP 6:
cabinet to wall.
Repeat steps 3-5 to secure the bottom
STEP 7: Insert metal shelf clips into the holes on the
sides of the cabinet.
See Figure 6.
Figure 6.
STEP 8: (2) Adjustable glass shelves are provided with
mounting hardware. Remove the protective foam from
the glass shelves, and place your glass shelves in the
desired location.
See Figure 7.
Figure 7.
REV. OCT, 2013ronbow.comINSTALLATION GUIDE