Ronbow 600823 User Manual

LED MIRROR

601224
602523

MATERIALS NEEDED:

PHILIP SCREWDRIVER
LEVELING TOOL
DRILL

INSTALLATION SHEET

MATERIAL PROVIDED:

(2)WOOD SCREWS
(2)ANCHORS

ACCESSORIESMODEL: 600823

ALL WIRING SHOULD BE DONE BY A QUALIFIED LICENSED ELECTRICIAN.

WARNING: To reduce the risk of electrical shock, shut o power before wiring the cabinet.

CAUTION: Requires 120V 20AMP circuit.

CAUTION: The LED mirror must be wired to a 20AMP GFI (ground fault interrupter) circuit breaker when used in bathrooms

and all other locations required by the national electric code.

Circuit Breaker

Wall Terminal

20AMP CFI

Black Black

White White

Ground

LED mirror. Make sure mirror has enough clearance
from faucet and ceiling.

See Figure 1.

Figure 1.STEP 1: Determine the ideal location of your new

1”

Minimum to Ceiling

Minimum to Faucet

1”

REV. OCT, 2013ronbow.comINSTALLATION GUIDE

LED MIRROR

601224
602523

STEP2: Drill pilot holes into the wall.

See Figure 2.

STEP 3: Secure the anchors in the wall, and then

fasten the screws provided into the anchor.

Note: Allow about 1/8” clearance from screw head to wall.

INSTALLATION SHEET

Figure 2.

Pilot Holes

ACCESSORIESMODEL: 600823

STEP 4:

If the mirror is not flush to the wall it is
recommended to cut the plug and hard wire to the
house. In this case we recommend a licensed
electrician.

See Figure 3.

Note: It is recommended you have a wall outlet within the
recessed area so the mirror can be flush against the wall.

STEP 5: Line up the keyhole hardware on the back

of the mirror to the screws on the wall, and allow the
mirror to sit in place.

Figure 3.

Figure 5.

Wall
Outlet

Wall

Wall

Recessed
Area

Wire

Mirror

See Figure 4.

Anchor

Screw

Mirror

REV. OCT, 2013ronbow.comINSTALLATION GUIDE