Rolls RPL108 User Manual
LIMITED WARRANTY
This product is warranted to the original consumer purchaser to
be free from defects in materials and workmanship under normal installation, use and service for a period of one (1) year from the date of purchase as shown on the purchaser’s receipt.
The obligation of Rolls Corporation under this warranty shall be
limited to repair or replacement (at our option), during the warranty
period of any part which proves defective in material or workmanship
under normal installation, use and service, provided the product is
returned to Rolls Corporation, TRANSPORTATION CHARGES PREPAID. Products returned to us or to an authorized Service Center must be
accompanied by a copy of the purchase receipt. In the absence of such
purchase receipt, the warranty period shall be one (1) year from the date
of manufacture.
This warranty shall be invalid if the product is damaged as a
result of defacement, misuse, abuse, neglect, accident, destruction or
alteration of the serial number, improper electrical voltages or currents,
repair, alteration or maintenance by any person or party other than our
own service facility or an authorized Service Center, or any use violative
of instructions furnished by us.
This one-year warranty is in lieu of all expressed warranties,
obligations or liabilities. ANY IMPLIED WARRANTIES, OBLIGATIONS, OR LIABILITIES, INCLUDING BUT NOT LIMITED TO THE
IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS
FOR A PARTICULAR PURPOSE, SHALL BE LIMITED IN DURATION TO THE ONE YEAR DURATION OF THIS WRITTEN LIMITED WARRANTY. Some states do not allow limitations on how long
an implied warranty lasts, so the above limitation may not apply to you.
RPL108
POWER CONDITIONER AND
RACK LIGHT
POW ER
RACK LIGHTS
DIMMER
ON
OFF
MAX
MIN
M AX IM UM LO A D: SW ITCH ED O UTL ETS 120VA C, 15A, 1800 WA TTS
AC IN
120VAC, 15A, 60Hz
MODEL RPL108
RPL108
POW ER CONDITIONER AND RACK LIGHT
PULL
1800 W A TTS M A X
RISQUE DE CHOC - NE PAS ENLEVER
AVIS: RISQUE DE CHOC ELECTRIQ UE - NE PAS OUVRIR
WARNING
:
DO NOT EXPOSE THIS EQUIPMENT TO RAIN
OR MOISTURE.
PULL
CAUTION:
NO USER SERVICABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
RESET
ON
OFF
REAR OUTPUTS
TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT NOT REMOVE BACK.
IN NO EVENT SHALL WE BE LIABLE FOR ANY SPECIAL,
INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF
THIS OR ANY OTHER WARRANTY, EXPRESSED OR IMPLIED,
WHATSOEVER. Some states do not allow the exclusion or limitation of
special, incidental or consequential damages so the above limitation or
exclusion may not apply to you. This warranty gives you specific legal
rights, and you may also have other rights which vary from state to state.
Rolls Corporation
Salt Lake City, UT
5/99
Owners Manual
INTRODUCTION
Thank you for purchasing the ROLLS RPL108 Pow er Conditioner and
Rack Light. Please read the following owners manual carefully to get the
most from this product.
FEATURES:
• Eight switched AC outlets
• Two light modules
Dimmer to adjust light modules brightness
Adjustable swiv el and pull-out positioning
The RPL108 protects your delicate electronic equipment by combining a
high voltage varistor (MOV) surge and transient suppressor with an RFI/
EMI interference filter. The fast-acting suppression circuit responds in less
than a nanosecond, clamping transient voltages to safe levels . The filter
works to prevent noise from fluorescent lights, certain dimmers, radio
transmitters, and similar sources of "electronic pollution" from contaminating the AC line and from there, leaking into sensitive audio, video, or
computer circuits.
OPERA TION
MAXIMUM LOAD
The eight circuit breaker protected outlets are rated at 15 amps, which is
equivalent to 1800 watts at 120 volts. If the total load on the RPL108
(combining all outlets) exceeds 15 amps, the circuit breaker will trip,
cutting off power to y our rack. If this happens, reduce the load by unplugging one or more units from the RPL108. Then push the circuit breaker
button in to reset it.
unscrew the cap on the end of each light tube, remove the old bulb and
replace.
CA UTION - BURN WARNING:
during normal operation.
The caps and light tubes become hot
Av oid b urning your fingers by allowing the cap to
cool completely before unscre wing it.
Do not push the tubes in while the caps are unscrewed. If you find that the
heat from the tubes is excessive, reduce the setting of the Dimmer
control, or substitute a 4-Watt b ulb .
POWER SWITCHES
The RPL108 has a master POWER switch for the rear outlets as well as
the lights. This s witch glows when the unit is on.
To turn on the lamps, switch the RACK LIGHTS switch to the ON position,
and adjust the DIMMER control for the desired brightness. The lights do
not turn off automatically when the tubes are pushed in, so be sure to
switch the RACK LIGHTS switch to the OFF position before pushing in
the tubes.
POW ER
RACK LIGHTS
DIMMER
ON
OFF
MAX
MIN
M AX IM UM LO A D: SW ITCH ED O UTL ETS 120VA C, 15A, 1800 WA TTS
AC IN
120VAC, 15A, 60Hz
MODEL RPL108
RPL108
POW ER CONDITIONER AND RACK LIGHT
PULL
1800 W A TTS M A X
RISQUE DE CHOC - NE PAS ENLEVER
AVIS: RISQUE DE CHOC ELECTRIQ UE - NE PAS OUVRIR
WARNING
:
DO NOT EXPOSE THIS EQUIPMENT TO RAIN
OR MOISTURE.
PULL
CAUTION:
NO USER SERVICABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
RESET
ON
OFF
REAR OUTPUTS
TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT NOT REMOVE BACK.
LAMPS
The RPL108 lamps pull out easily and may be aimed to provide the best
illumination for your equipment. Each lamp is supplied with a 7 watt nightlight bulb . Replacements are readily availab le at most hardware stores, or
wherever household lightb ulbs are sold.
BULB REPLACEMENT
Bulbs are easily replaced without removing the unit from the rack. Simply
Loading...