Rolls RM74 User Manual

USER GUIDE

ROLLS CORPORATION

SALT LAKE CITY, UTAH

7/06

www.rolls.com

SPECIFICATIONS

Source:

22K Ohms RCA

Mic Insert: 22K Ohms 1/4” TRS insert

Source: 24 dBV

Source: 26 dB

Tone Controls: +/-12 dB 100 Hz Bass

+/-12 dB 11kHz Treble

Weight: 5 lbs. (2.3 kg)

tion to the Output of the effects processor.

The RM75 effects insert is mono, so if the

tion about operating it in mono.

the microphone and adjust the levels of your effects processor for the desired process and

Thank your for your purchase of the Rolls RM74 MixMate 2 Mic / Source Mixer. The RM74

Your RM74 was carefully packed at the factory in a protective carton. Nonetheless, be

jack parallels the Channel 1 Microphone Input on the rear panel.

NOTE: The following two descriptions are for Mic 1 and Mic 2.

TONE: Adjusts the relative frequency components of the Mic signal. Turning this control

TREBLE: Varies the amount of the high frequency portion (10 kHz) of the Source signals.

INPUT: Connects to the included Rolls PS27 power adapter.

1/4”: Tip-Ring-Sleeve balanced ouput jacks

to an effects processor. Allows for effects to be added to the microphone signals.

fore, begin with all Levels completely counter-clockwise (off). Keep the Headphone Level

There will be nothing heard from the Main Outputs until you increase the level of a Source

You may now select a different channel by moving the Cue Select switch to another

PS27