Rolls PS16 POWER CENTER User Manual
-
+
PS16
12VAC
balanced
Power Supply
Personal Monitor
unbal
Signal Distribution
POWER CENTER
LINE INPUTS
PERSONAL MONITOR
PS16
www.rolls.com
WARNING:
THIS UNIT MAY BE DAMAGED IF THE LIGHT IS OFF
WHEN POWER IS APPLIED - IMMEDIATELY UNPLUG
ALL OUTPUTS. USE TIP-RING-SLEEVE PLUGS ONLY.
power
status
POWER CENTER
OUT 1 OUT 2 OUT 3 OUT 4
Owners Manual
REQUIRED FOR THE OUTPUTS OF THIS
READ THIS MANUAL FOR IMPORTANT OPERA-
TION INSTRUCTION. TIP-RING-SLEEVE PLUGS
ARE
UNIT.
PS16
The PS16 supplies the DC power and distributes
the Monitor signal to up to ten of the PM50s, the
PM55, and the PM351 units. This
dramatically increases efficiency and eliminates
the need for multiple wall-warts and adapter
cables.
• Supplies power for up to ten PM50s,
PM55, and PM351 units.
• Directly supplies a monitor signal to the
above listed units.
• Unbalanced 1/4" and TRANS
FORMER-balanced XLR inputs.
POWER CENTER
Rolls Corporation
Salt Lake City, UT
12/10
1
AHCS.61SP
Rev:
1
Sheet of
CONNECTION / OPERATION
Status LED should light. If not, immediately unplug the power as this
(balanced or unbalanced).
• Connect the PS12 adapter to the VAC input of the PS16. The Power/
• Connect the Send of the mixer to the appropriate Input of the PS16
Outputs to the PM series Monitor Inputs. Refer to the Personal Monitor
• Connect the TIP-RING-SLEEVE STEREO cables from the PS16
indicates a short from the Ring of an Output jack to ground.
unit owners manual for proper operation of that unit.
SPECIFICATIONS
Input Power: VAC
Output Power: 12 VDC on the Ring terminal of each OUT jack.
Size: 3.125" x 3.125" x 1.25"
Weight: 1 lb (.45 Kg)
SCHEMATIC
J1
PHONE 1/4
XLR JACK M
LOW OUT
J2
XFMR AUDIO
T1
3
J11
2
HIGH OUT
PHONE 1/4
J3
PHONE 1/4
J4
PHONE 1/4
PM SERIES OUTS
C7
1U
3
O
G
U1
1
J2
PHONE 1/4
2
7812
I
1
2200UF 16V
D4
LDRR
D5
R1
4.7K
C17
1N4001
D3
1N4001
D1
231
J10
IN 9-15 VAC/VDC
5968 S 350 West
MURRAY UT 84107
ROLLS CORPORATION
D2
1N4001
JAPDC
Document Number:
22 MAY 2002
Ba
PS16 PM POWER CENTER
Date:
1N4001
-
+
12VAC
balanced
LINE INPUTS
unbal
PS16
www.rolls.com
WARNING:
THIS UNIT MAY BE DAMAGED IF THE LIGHT IS OFF
WHEN POWER IS APPLIED - IMMEDIATELY UNPLUG
ALL OUTPUTS. USE TIP-RING-SLEEVE PLUGS ONLY.
power
status
PERSONAL MONITOR
POWER CENTER
OUT 1 OUT 2 OUT 3 OUT 4
INTRODUCTION
Thank you for your purchase of the PS16 Personal Monitor Power Center.
to ten of the PM50s, the PM55, and the PM351 units. This dramati-
The PS16 supplies the DC power and distributes the Monitor signal to up
and adapter cables.
cally increases efficiency and eliminates the need for multiple wall-warts
The power AND monitor signal are carried from each PS16 output using
ers may be daisy-chained.
351. Using stereo “Y” adapters, up to ten of the Personal Monitor Amplifi-
an ordinary 1/4" stereo cable to the Monitor input of the PM50s, 55, and
NOTE: Very old PM50s and PM50sob units may not
will not work with a PS16.
work with a PS16.
ground lift jumper and mono/stereo jumper
Any PM50s or PM50sob WITHOUT a
FEATURES
- Supplies power for up to ten PM50s, PM55, and PM351 units.
- Directly supplies a monitor signal to four of the above units, indirectly (by
- Unbalanced 1/4" and TRANSFORMER-balanced XLR inputs.
using stereo “Y” adapters) will provide signal for up to ten units.
DESCRIPTION
Monitor or Auxiliary Send.
LINE INPUTS
UNBALANCED: 1/4' Tip-Sleeve jack. Connects to a mixer's unbalanced
BALANCED: Transformer isolated
female XLR jack.Connects to a mixer's
balanced Monitor or Auxiliary Send.
PS12 power adapter.
12VAC: Connects to the included Rolls
OUT 1 - 4: 1/4" Tip-Ring-Sleeve jacks.
The Tip of the connector contains the
DC required to operate the Personal
audio signal, the Ring has the 12 volts
Monitor devices, and the Sleeve con-
nects to ground.
Loading...