Rolls PS16 User Manual
-
+
PS16
Personal Monitor
POWER CENTER
12VAC
balanced
LINE INPUTS
Power Supply
unbal
PERSONAL MONITOR
Signal Distribution
PS16
www.rolls.com
WARNING:
THIS UNIT MAY BE DAMAGED IF THE LIGHT IS OFF
WHEN POWER IS APPLIED - IMMEDIATELY UNPLUG
ALL OUTPUTS. USE TIP-RING-SLEEVE PLUGS ONLY.
power
status
POWER CENTER
OUT 1 OUT 2 OUT 3 OUT 4
Owners Manual
READ THIS MANUAL FOR IMPORTANT OPERA-
TION INSTRUCTION. TIP-RING-SLEEVE PLUGS
UNIT.
ARE REQUIRED FOR THE OUTPUTS OF THIS
LIMITED WARRANTY
This product is warranted to the original consumer purchaser to be
free from defects in materials and workmanship under normal installation, use
and service for a period of one (1) year from the date of purchase as shown on
the purchaser’s receipt.
The obligation of Rolls Corporation under this warranty shall be
limited to repair or replacement (at our option), during the warranty period of
any part which proves defective in material or workmanship under normal
installation, use and service, provided the product is returned to Rolls Corporation, TRANSPORTATION CHARGES PREPAID. Products returned to us or to
an authorized Service Center must be accompanied by a copy of the purchase
receipt. In the absence of such purchase receipt, the warranty period shall be one
(1) year from the date of manufacture.
This warranty shall be invalid if the product is damaged as a result of
defacement, misuse, abuse, neglect, accident, destruction or alteration of the
serial number, improper electrical voltages or currents, repair, alteration or
maintenance by any person or party other than our own service facility or an
authorized Service Center, or any use violative of instructions furnished by us.
This one-year warranty is in lieu of all expressed warranties,
obligations or liabilities. ANY IMPLIED WARRANTIES, OBLIGATIONS, OR
LIABILITIES, INCLUDING BUT NOT LIMITED TO THE IMPLIED
W ARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, SHALL BE LIMITED IN DURATION TO THE ONE YEAR
DURATION OF THIS WRITTEN LIMITED WARRANTY. Some states do not
allow limitations on how long an implied warranty lasts, so the above limitation
may not apply to you.
IN NO EVENT SHALL WE BE LIABLE FOR ANY SPECIAL,
INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF THIS
OR ANY OTHER WARRANTY, EXPRESSED OR IMPLIED, WHATSOEVER. Some states do not allow the exclusion or limitation of special,
incidental or consequential damages so the above limitation or exclusion may
not apply to you. This warranty gives you specific legal rights, and you may also
have other rights which vary from state to state.
PS16
POWER CENTER
The PS16 supplies the DC power and distributes
the Monitor signal to up to ten of the PM50s, the
PM50sOB, and the PM350 units. This
dramatically increases efficiency and eliminates
the need for multiple wall-warts and adapter
cables.
• Supplies power for up to ten PM50s,
PM50sOB, and PM350 units.
• Directly supplies a monitor signal to the
above listed units.
• Unbalanced 1/4" and TRANS
FORMER-balanced XLR inputs.
Rolls Corporation
Salt Lake City, UT
6/02
INTRODUCTION
Thank you for y our purchase of the PS16 Personal Monitor Power Center.
The PS16 supplies the DC power and distributes the Monitor signal to up
to ten of the PM50s, the PM50sOB, and the PM350 units. This dramatically increases efficiency and eliminates the need for multiple wall-w arts
and adapter cables.
The power AND monitor signal are carried from each PS16 output using
an ordinary 1/4" stereo cable to the Monitor input of the PM50s, sOB, and
350. Using stereo “Y” adapters, up to ten of the Personal Monitor Amplifi-
ers may be daisy-chained.
NOTE: Older PM50s and PM50sOB units may need
a slight modification in order to operate with the
PS16. Any PM50s or PM50sOB WITHOUT a
ground lift jumper and mono/stereo jumper will need
this modification. Call the factory at (801) 263-9053
for details.
FEATURES
- Supplies power for up to ten PM50s , PM50sOB , and PM350 units .
- Directly supplies a monitor signal to four of the abov e units , indirectly (by
using stereo “Y” adapters) will pro vide signal for up to ten units.
- Unbalanced 1/4" and TRANSFORMER-balanced XLR inputs.
DESCRIPTION
LINE INPUTS
UNBALANCED: 1/4' Tip-Sleeve jack. Connects to a mixer's unbalanced
Monitor or Auxiliary Send.
BALANCED: Transformer isolated
female XLR jack.Connects to a mix er's
balanced Monitor or Auxiliary Send.
12V A C: Connects to the included Rolls
PS12 power adapter .
OUT 1 - 4: 1/4" Tip-Ring-Slee v e jacks .
The Tip of the connector contains the
audio signal, the Ring has the 12 volts
DC required to operate the Personal
Monitor devices, and the Slee v e connects to ground.
unbal
balanced
LINE INPUTS
PERSONAL MONITOR
POWER CENTER
power
status
WARNING:
THIS UNIT MAY BE DAMAGED IF THE LIGHT IS OFF
WHEN POWER IS APPLIED - IMMEDIATELY UNPLUG
ALL OUTPUTS. USE TIP-RING-SLEEVE PLUGS ONLY.
OUT 1 OUT 2 OUT 3 OUT 4
12VAC
PS16
www.rolls.com
+
-
CONNECTION / OPERA TION
• Connect the Send of the mixer to the appropriate Input of the PS16
(balanced or unbalanced).
• Connect the PS12 adapter to the 12V AC input of the PS16. The Power/
Status LED should light. If not, immediately unplug the po wer as this
indicates a short from the Ring of an Output jack to ground.
• Connect the TIP-RING-SLEEVE STEREO cab les from the PS16
Outputs to the PM series Monitor Inputs. Refer to the Personal Monitor
unit owners manual for proper operation of that unit.
FOR APPLICATION DIAGRAMS, VISIT OUR WEBSITE
AT WWW.R OLLS.COM.
SPECIFICATIONS
Input P o wer: 12 VAC, 700 mA
Output P o w er: 12 VDC on the Ring terminal of each OUT jack.
Size: 3.125" x 3.125" x 1.25"
Weight: 1 lb (.45 Kg)
SCHEMATIC
PHONE 1/4
XLR JACK M
J11
1 2
J2
PHONE 1/4
IN 9-15 VAC/VDC
J10
JAPDC
T1
3
XFMR AUDIO
U1
R1
4.7K
1
D5
LDRR
7812
I
O
G
2
Date:
3
PS16 PM POWER CENTER
Ba
22 MAY 2002
D4
2200UF 16V
1N4001
D1
1N4001
D3
2
3
1
1N4001
D2
1N4001
C17
J1
LOW OUT
J2
PHONE 1/4
J3
HIGH OUT
PHONE 1/4
J4
PHONE 1/4
PM SERIES OUTS
C7
1U
ROLLS CORPORATION
5968 S 350 West
MURRAY UT 84107
Document Number:
PS16.SCH A
Sheet of
Rev:
1
1
Loading...