ROLDY KAL215MIC Users manual

1

3

2

5

6

10

11

14

4

8

9

7

13

12

15

16

17

18

19

1. USB HOST

2. SD PLUG

3. Microphone A antena

4. Microphone B antena

5. MICROPHONE VOLUME

Use this control to set the volume level of Microphone

20

6. ECHO FOR MICROPHONE

7. Treble

8. Bass

9. Master volume

10/11. 6.35mm Mic input

12. RCA Line Input/ RCA Line Output

13. Line in and MP3 Volume

14. Wireless Microphone A Volume

15. Wireless Microphone B Volume

16. Power switch of Wireless Microphone

17. DC 24 V connector

18. ON/OFF POWER SWITCH

19.AC POWER CONNECTOR

20.Handle Microphone A and Handle Microphone B

The AC inlet incorporates the voltage selector.
Ensure that the main voltage source matches
the voltage rating. Extract and place it according
to the value. The cselected one will be showed in

the correct reading position.

220-240

110-120

115-230V AC 50-60Hz

Device set at 110/120V AC

FCC STATEMENT :

This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:

Reorient or relocate the receiving an　 tenna.
Increase the separation between the equipment and receiver.　
Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.　

RF warning statement:

The device has been evaluated to meet general RF exposure requirement. The device
can be used in portable exposure condition without restriction.