ROLDY KAL215ABT User Manual

User Manual

2

5

7

9

1

3

4

6

11

8

12

14

10

A

B

C

D

E

F

A.MODE: Press to select USB/SD/Bluetooth/FM
B.PLAY: Press to play s son or pause while playing a song.

C.PAUSE: Press to stop play.

D.REPT:Press to select repeat mode: one, all or random.

9

15

E:PREV: Press to jump to the previous song.

F:NEXT: Press to jump to next song.

1. USD HOST

2. SD PLUG

3. MP3 VOLUME CONTROL

4. 5-BAND EQ
6/7. MICROPHONE INPUT

Allows you to connect a microphone with 6.35mm jack or XLR connector.

7/8. Line Input

Allows you to connect an externel device(CD, radio/ DVD ,ect) with RCA /6.35MM JACK /XLR connector.

9. SPEAKON OUTPUT

Power for passiver speaker

10. Line Out

Use 6.35mm jack to connect another active speaker.

11. Mic Volume control

Use this control to set the volume level of Microphone

12. Line-in volume control

Use this control to set the volume of Line-in signal

13. Volume control

Set the volume level

14. ON/OFF POWER SWITCH

15.AC POWER CONNECTOR

The AC inlet incorporates the voltage selector.
Ensure that the main voltage source matches
the voltage rating. Extract and place it according
to the value. The cselected one will be showed in

the correct reading position.

115-230V AC 50-60Hz

220-240

110-120

Device set at 110/120V AC

Federal Communications Commission (FCC) Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generate, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:

 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.
 Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.

FCC Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.

RF exposure warning

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
The equipment must not be co-located or operating in conjunction with any other antenna or
transmitter.