ROLDY KAL215AB User Manual
Manual
This equipment is amplifier of active BT speaker box,and no back
cover. The buyer of manufacturers require a matching cover. And
Fixed, into a box shape. Support Bluetooth version: V2.0 + EDR
1. Turn on power. Press the MODE button under the LED screen until
BLUETOOTH appears on t he LED s creen. Perform bluetooth paring
operations after it is on for 30 seconds.
2. After i t enters paring mode, enabl e the bluetooth function for the
devices such as bluetooth PC,cell phone and any other digital products
with bluetooth function. Search bluetooth devices or new devices to
find BLUETOOTH and connect it. Password input for paring is
needed,and the default password is :0000.
3. After successful paring, you can play music.
4. To change the play device duri ng normal operation, disconnect the
connected bluetooth PC and/or cell phone,and then perform paring
connection for other bluetooth devices.
The Bluetooth® word mark and logos are owned by Bluetooth SIG Inc.
FCC Caution: Any changes or modifications not expressly approved by
the party responsible for compliance could void the user's authority to
operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This device and its antenna(s) must not be co-located or operating in
conjunction with any other antenna or transmitter.
NOTE: This equipment has been tested and found to comply with the li
mits for a Class B digital device, pursuant to Part 15 of the FCC
Rules.
These limits aredesigned to provide reasonable protection against harm
ful interference in aresidential installation. This equipment generates,
uses and can radiate radiofrequency energy and, if not installed and
used in accordance with theinstructions, may cause harmfulinterference
to radio communications.
However,there is no guarantee that interference will not occur in a parti
cular installation.
If this equipment does cause harmful interference to radio or television
reception,which can be determined by turning the equipment off and on
, the user isencouraged to try to correct the interference by one or more
of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Loading...