In t roducing t he nex t step in audio transport flexi bi l ity
-
the 24 x16 Digital Snake
S TAGE UN I T
S
-
2416
A new standard in digital stage units
24 input x 16 ou tpu t analog and 8 input x 8 output di git al, for a total of 32 inpu t and 24 output channels
Two RE AC port s to cascade to addit ional snake for expanded inputs and output s or for a full y redundant , zero- loss audio backup
Ne wly develop ed high- grade discrete mic preamps on all analog input s
S TAG E U N I T
S-2416
24 inputs and 16 outputs in a 4U rack size
The chassis houses 24 analog inputs and 16 analog
outputs in an EIA rack-mount size of 4U. All input sections
are equipped with discrete mic preamps that have been
freshly designed to be transparent with uncolored sound.
What's more, each XLR jack features three-colored light s
th at clearly communi cate the status of phantom power,
clipping, and signal presence. The use of Neut rik connectors
assures ruggedness for demanding environments.
Newly developed, high-grade discrete mic preampsNewly developed, high-grade discrete mic preamps
AES/EBU ports provide a digital input/output
environment
The rea r panel provides AES /EBU connectivity (25-pin D-sub
type) for 8 channels of input and output, enabling connection
to speaker processors, amps, and other devices capable of
AES / EBU input and/or out p ut . Input via AES is assigned to
channels 25 through 32 and output is selectable by a mode
switch. When combined with analog input and output, the
S-2416 can achieve up to 32 inputs and 24 outputs.
When using AES/EBU input /output, exter nal sync ing to a master clock is required.
*
Use third-party AES/EBU breakout cabl es to make connect ions.
Pin layout of AES/EBU connector
Data In Ch. Data Out Ch.
Signal
1-2 3-4 5 -6 7- 8 1-2 3-4 5-6 7-8
Hot 1 2 3 4
Pin
Cold 14 15 16 17
5 6 7 8 10,12,13, 22
18 19 2 0 21
Open GND
9 , 11
23, 24,25
Two REAC connectors, enabling support for
redundant transmission
With two REAC connectors – a main and a backup – a
redundant REAC network is possi ble. If a problem occurs
with the main line, operation instantly switches to the
backup with no break up or click /pop in sound. What's
more, use of Neutrik Ethercon
connectors assures both a reliability
and ruggedness for any type of
environmen t .
Easily expand I/O with a cascade connection
The S - 2416 is the f i r st Digi tal Snake capable of a cascade
connection. Switching the device to Cascade mode and
connecting another Digi tal Snake makes it possible to expand
inputs and outputs up to 40x 40 channels. Any of four patterns
can be selected for the number of channels output to the
additional Digi tal Snake with a cascade connection : 40 (1 - 40
ch), 32 (9 -
Cascade connection example
40 ch), 24 (17 - 40 ch), and 16 (25 - 40 ch).
1-24in
Analog
S-2416
1-16out
Analog
17-24ou t
(
AES/EBU
)
40in
32out
25-32out
M-480
25-40in
Analog
Analog
S-1608
High sampling rate of 96 kHz and word-clock
input/output
The S-2416 supports a high bit rate of 24 bits and a h igh
sampli ng rate of 96 kHz. A mode switch enables selection
of 96 kHz, 48 kHz, or 44.1 kHz, when the S-2416 is switched
to Clock master mode. The unit is
also equipped with word-clock input
and output connectors (BNC) for
supplying a master clock signal when
using t he AES /EBU connec t ion.
DIP switches for easily adjusting the configuration
DIP switches set the REAC mode,
AES/ EBU in/out , cascade settings,
and samp ling ra te.
MODE SWITCH
3
4
1
REAC SLAVE MODE
OFF
CLOCK SLAVE
O N
CLOCK MASTER
5
AES/ EBU IN PUT
OFF
ENA BLE
O N
DIS ABLE
2
REAC BACKUP MODE
OFF
BACKUP
O N
CASCADE
6
AES/ EBU OUTPUT
OFF
1- 8
O N
17-24
OFF
OFF
O N
O N
7
OFF
OFF
O N
O N
CASCADE OUTPUT
OFF
1 - 40
O N
9 -40
OFF
17- 40
O N
25- 40
8
SAM PLE R ATE
OFF
96 KHz
O N
48 KHz
OFF
44.1 KHz
O N
WORD CLOCK
MUTE ALL OUTPUTS button for silencing all output
The S-2416 is equipped with a MUTE ALL
OUTPUTS button to temporarily silence all
outputs - a handy feature when changing cable
connections.
Mode control via REAC, USB, or RS-232C
Mic preamps can be cont rolled using
any V-Mixer, R-1000, an S-4000R unit
connected by RS-232C, or by using the
S-4000 RCS remote-control software
on a computer
(
Mac or Windows
)
connected via USB.
S-4000RCS can be downloaded from
*
www. rolandsystemsgroup.net .
Front/back adjustable rack mounting for greater
freedom in installat ion
Rack-mount angl e bracke ts can be
attached not only at the front panel,
but also at the rear. This makes it
possible to mount the S-2416 with
ei ther fr ont o r rear or ientat ion
as needed.
Rol and S -2 416 : STAGE UNIT
Number of Channels 32 in 24 out
AD Conversion Sample Rate: 96.0 kH z, 48 kHz, 44.1 kHz
DA Conversion Sample Rate: 96.0 kHz, 48 kHz, 44.1 kHz
Frequency Response -2 dB / +0 dB
Total Harmonic Distortion + Noise 0.007 %
Dynamic Range
Channel Separation @ 1kHz
Nominal Input Level (Variable)
Non Clip Maximum Input level INPUT jac ks
Input Impedance INPUT ja cks
Nominal Output Level OUTPUT j acks
Maximam Output Level OUTPUT j acks
Output Impedance OUTPUT j acks
Recommended Load Impedance OUTPUT j acks
Residual Noise Level (IHF-A, typ.) OUTPUT j acks
Equivalent Input Noise Level (E.I.N.) INPUT jac ks
Network Latency 375 microseconds when using REAC cable only
Connectors INPUT jac ks
Signal Processing: 24 bits
Signal Processing: 24 bits
INPUT jac ks (1 to 24): 110 dB (typ.
INPUT jac ks (1 to 24): 103 dB (Input Ga in: +4 dBu, IH F-A, typ.
OUTPUT j acks (1 to 16): 110dB (typ.
.
(
AD to REAC to DA L atency: ab out 1.2 ms)*1
OUTPUT j acks (1 to 16): XLR typ e, balan ced
AES/EBU c onnecto r: DB-25 typ e
REAC por t: RJ-45 EtherCon t ype
WORD CLOCK c onnecto r: BNC ty pe
REMOTE co nnector : DB-9 ty pe
COMPUTER port: USB type B
*
*
14m A(maximum load
(
@ +4 dB u, 10 Hz to 40 kHz, Sampl e Rate : 96 kHz, typ.
(
Pad: Off, In put Gain: -10 dBu, 20 Hz to 20 k Hz, typ.
-65 to -10 dBu (PAD: O ff) . -45 to +10 dBu (PAD: O n
(
1 to 24): +28dBu (1 kHz, 10 k ohms lo ad, typ.
(
1 to 24): 7 k ohms
(
1 to 16): +4 dBu (Load impe dance: 10 k ohm s, typ.
(
1 to 16): +22 dBu (Load impe dance: 10 k ohm s, typ.
(
1 to 16): 600 ohm s (typ.
(
1 to 16): 10 k ohms or grea ter
(
1 to 16): -84 dBu
(
1 to 24): -128 dB (Input Ga in: -65 dBu , IHF-A, ty p.
(
1 to 24): XLR typ e, balan ced, phan tom power
XLR typ e: 1 GND, 2 HOT, 3: COLD
phantom power: DC +48V(unloaded maximum),
)
)
) (
All XLR t ype inpu ts
)
Power Consumption 62 W
Dimensions 482
Weight 9.7 kg 21 lbs 7 oz
)
)
)
)
)
Operation Temperature
Accessories
0 dBu = 0.775 Vrms
*
In the inte rest of prod uct improvement, t he specificat ions and /or app earance of this un it are subject to
*
change without prior notice.
When a RE AC Splitter S-40 00D or a swi tching hub is used i n-line with REAC c ables, th e network latenc y
*
will inc rease by th e amount of proces sing del ay introduced by th e splitt ing device itsel f. The a ctual de lay is
dependant upon the specifications of the splitting device, though the maximum delay amount for a single
splitting device should be about 200 microseconds.
)
)
(W)
x 348 (D) x 177 (H) mm
19 (W) x 13- 3/4 (D) x 7 (H) inches
(
EIA-1U rack mountable
.
+0 to +40 deg rees Cel sius . +32 to +104 degrees Fah renhei t
.
Power cord . Owner's manual . Rubber f oot x 4
)
DIMENSIONS
)
430
328.2
)
337.2
7
101.6
Unit : mm
430
177
482
LINEUP
M-480 M-300
LIVE MIXING CONSOLE
48 mixing channels plus 6 stereo returns
Main LCR outputs, 16 AUX buses,
8 matrices
S-1608
16 x 8 Stage Unit
16 inputs and 8 outputs configuration
Compact, floor-based or
rack-mountable design
LIVE MIXING CONSOLE
32 mixing channels
Mai n LCR ou tp u ts, 8 AUX bus es,
4 mat r i ces
S-4000R
REMOTE CONTROLLER
Remote cont rol of al l input ga in
adju stmen ts, phantom powe r and
PAD settings
LIVE MIXING CONSOLE
32 mixing channels
Main LR outputs, 8 AUX buses,
4 matrices * ipad not included.
W100S-R
M-200i
REAC CABLE (100m
)
S-4000S 3208
32 x 8 Modula r St age Un i t
32 inpu ts and 8 outputs con fi gurati on
Hi gh Qual i ty Pre-a mps on each input
ch ann el conf igurable wi th analog or
digitial I/O cards
SC-W100S
REAC CABLE (100m
)
SC-W20F
REAC CABLE (20m
)
Roland Systems Group, a member of the worldwide group of Roland companies, is dedicated to the support of audio and
video professionals demanding excellence in both performance and system design. Through the development and support of
video and audio products, we endeavor to improve workflow and maximize creative possibilities.
www.rolandsystemsgroup.com/s2416
All specifications and appearances are subject to change without notice. Company names and product names
appearing in this document are registered trademarks or trademarks of their respective owners. Roland, REAC and
V-Mixer are either registered trademarks or trademarks of Roland Corporation in the United States and/or other
countries. It is forbidden by law to make an audio recording, video recording, copy or revision of a third party's
copyrighted work (musical work, video work, broadcast, live performance, or other work), whether in whole or in part,
and distribute, sell, lease, perform, or broadcast it without the permission of the copyright owner. Do not use this
product for purposes that could infringe on a copyright held by a third party. We assume no responsibility whatsoever
with regard to any infringements of third-party copyrights arising through your use of this product. Copyright 2014
Roland Corporation. All right reserved.
Prin ted in Japan. Mar. 2014 RAM-20044 PRS-PD
Loading...