Notice: For G-70 Version 1.05 Users
** BENDER CALIBRATION **
Calibrating the HARD RIGHT POSITION:
Move Pitch Bend lever to the right and press ASSIGN SW 1
Please read the following before updating your G-70.
If your G-70 currently uses software version 1.05, you will be asked to calibrate several settings after installing OS2.
* Please DO NOT turn off the power until you complete this calibration setting.
* Make sure that you correctly complete this setting, before moving to the next step.
1.
The G-70’s display shows the following message:
** BENDER CALIBRATION **
Calibrating the CENTER POSITION:
Release the Pitch Bend lever, Press ASSIGN SW 1
Move the BENDER/MODULATION lever left or right once, then let it return to the central position,
press the ASSIGN SW 1 button.
2.
The display shows the following message:
** BENDER CALIBRATION **
Move Pitch Bend lever to the left and press ASSIGN SW 1
Move the BENDER/MODULATION lever to the far left and hold, press the ASSIGN SW 1 button.
3.
The display shows the following message:
Move the BENDER/MODULATION lever to the far right and hold, press the ASSIGN SW 1 button.
4.
The display shows the following message:
Calibrating the HARD LEFT POSITION:
** MODUL CALIBRATION **
Release the Modulation lever
Press the ASSIGN SW 1
Release the BENDER/MODULATION lever so that it returns to the central position, press the ASSIGN SW 1 button.
5.
The display shows the following message:
** MODUL CALIBRATION **
Press the Modulation lever to the back of the G-70
Push the BENDER/MODULATION lever all the way towards the back of the G-70 and hold,
press the ASSIGN SW 1 button.
The G-70 exits the calibration routine and returns to the main menu.
6.
Power Off and Power On again, and you can move on to the next updating procedure.
and press ASSIGN SW 1
All rights reserved. No part of this publication may be reproduced in
any form without the written permission of ROLAND CORPORATION.
SR-G01 LEAFLET
*40673612 -01 *
Copyright © 2005 Roland Corporation.
40673612 1PD