Roland DT-30 User Manual

Owner’s Manual

Thank you, and congratulations on your choice of the Roland Drum Throne DT-30.

Before using this unit, carefully read the sections entitled: “USING THE UNIT SAFELY” and “IMPORTANT NOTES” (back page). These sections provide important information concerning the proper operation of the unit. Additionally, in order to feel assured that you have gained a good grasp of every feature provided by your new unit, Owner’s Manual should be read in its entirety. The manual should be saved and kept on hand as a convenient reference.

202

ンDT-30

202

Part Names

Seat

	T-Bolt
	4 T
		Memory Lock
3	Square-Headed Bolt
3		Upper Tube
		Upper Tube

Die-Cast Pipe Joint		T-Bolt
Die-Cast Pipe Joint		2 T
		2 T

	Round Bolt
	1
962a	962a
* In the interest of product improvement, the specifications
and/or appearance of this unit are subject to change
without prior notice.

03896190 2TM

1.Open the legs of the tripod base and

then tighten the round bolt 1 .

2.Loosen t-bolt 2 and pull up the upper tube high enough so the tripod stand is able to stand flat on the floor. Slightly tighten t-bolt 2 (you will tighten it fully later).

3.Loosen the square-headed bolt 3 of the memory lock with a standard drum key (sold separately). Then lower the memory lock to the middle

of the upper tube and tighten 3 slightly.

4.Place the seat on the upper tube.

Firmly tighten the t-bolt 4 of the drum seat.

5.Loosen the t-bolt 2 and adjust the height of the seat to the desired position, and then firmly tighten the t- bolt 2 .

6.Loosen the square-headed bolt 3 of the memory lock and lower the memory lock to the top of the die-cast pipe joint. Use a standard drum key to tighten the square-headed bolt 3 of the memory lock firmly.

The memory lock helps preventing the upper tube from declining while in use.

*Keeping the memory lock in the position allows you to set up much more quickly from next time as the memory lock “memorizes” the desired height.

7.If you need to make further height adjustments, repeat steps 5 and 6.

Once the desired height is achieved, firmly tighten the square-headed bolt

3 of the memory lock.

2.T 2T 2

3.3

4.T4

5.T 2T 2

6.3 3

7.5 6

Used for instructions intended to alert the user to the risk of death or severe injury should the unit be used improperly.

Used for instructions intended to alert the user to the risk of injury or material damage should the unit be used improperly.

*Material damage refers to damage or other adverse effects caused with respect to the home and all its furnishings, as well to domestic animals or pets.

The symbol alerts the user to important instructions or warnings.The specific meaning of the symbol is determined by the design contained within the triangle. In the case of the symbol at left, it is used for general cautions, warnings, or alerts to danger.

The symbol alerts the user to items that must never be carried out (are forbidden). The specific thing that must not be done is indicated by the design contained within the circle. In the case of the symbol at left, it means that the unit must never be disassembled.

The ● symbol alerts the user to things that must be carried out. The specific thing that must be done is indicated by the design contained within the circle. In the case of the symbol at left, it means that the powercord plug must be unplugged from the outlet.

•Before using this unit, make sure to read the

instructions below, and the Owner’s Manual.

...............................................................

•Do not open or perform any internal modifications on the unit.

...............................................................

•Do not attempt to repair the unit, or replace parts within it (except when this manual provides specific instructions directing you to do so). Refer all servicing to your retailer, the nearest Roland Service Center, or an authorized Roland distributor, as listed on the “Information” page.

...............................................................

• Never use or store the unit in places that are:

• Subject to temperature extremes (e.g., direct sunlight in an enclosed vehicle, near a heating duct, on top of heatgenerating equipment); or are

•Damp (e.g., baths, washrooms, on wet floors); or are

•Humid; or are

•Exposed to rain; or are

•Dusty; or are

•Subject to high levels of vibration.

...............................................................

•Make sure you always have the unit placed so it

is level and sure to remain stable. Never place it on

stands that could wobble, or on inclined surfaces.

................................................................

•In households with small children, an adult should

provide supervision until the child is capable of

following all the rules essential for the safe operation of the unit.

................................................................

•Protect the unit from strong impact.

(Do not drop it!)

................................................................

•Never climb on top of, nor place heavy objects on the unit.

................................................................

•Should you remove the square-headed bolt or

round bolt, keep them in a safe place out of children’s reach, so there is no chance of them being swallowed accidentally.

................................................................

IMPORTANT NOTES

In addition to the items listed under “USING THE UNIT SAFELY” on this page, please read and observe the following:

Maintenance

•Never use benzine, thinners, alcohol or solvents of any kind, to avoid the possibility of discoloration and/or deformation.

定される内容を表わしています。

び家畜・ペットにかかわる拡大損害を表わしています。

す。

左図の場合は、「一般的な注意、警告、危険」を表わしています。

ます。

左図の場合は、「分解禁止」を表わしています。

● ●

● に、以下の指示と取扱説

さい。

..................................................................

● で、取扱説明書に書かれていないことは、絶対にしないでください。必ずお買い上げ店またはロー

..................................................................

● り、機器の上に重いものを置かないでください。

..................................................................

● 改造された場合、以後の性能について保証できなくなります。また、修理をお断りする場合もあります。