Roksan Audio LIII User Manual
Kandy
I
N
T
E
G
R
A
T
E
D
I
N
T
E
G
R
A
I
N
T
E
G
A
M
P
M
M
P
P
L
L
L
A
A
R
I
I
T
A
T
F
I
E
F
I
E
I
F
I
E
USER MANUAL
ROKSAN AUDIO LIMITED
6 NORTHFIELD INDUSTRIAL ESTATE
BERESFORD AVENUE ALPERTON
MIDDLESEX HA0 1NW ENGLAND
TEL. +44 (0)208 900 6801
+44 (0)208 900 6802
FAX. +44 (0)208 900 0734
wwwwww..rrookkssaann..ccoo..uukk
eemmaaiill iinnffoo@@rrookkssaann..ccoo..uukk
E
E
R
R
R
D
D
INTRODUCTION Kandy Integrated Amplifier
Congratulations on your purchase of the ROKSAN Kandy Integrated Amplifier. This Integrated Amplifier is
designed and manufactured to the highest specification and rigorously tested to offer you many years of troublefree pleasure.
Your Kandy Integrated Amplifier is at the heart of your hi-fi system. Its correct installation, set-up and operation
will have a profound influence on the sonic performance of the entire hi-fi installation.
Please read the contents of this manual thoroughly. It will help you to understand your hi-fi equipment better and
enhance your listening pleasure.
This manual is divided into the following sections:
• Safety Instructions (Accompanying card)
• Introduction
• Cautions
• Installation
• Setup
• Operation
• Troubleshooting
• Guarantee
• Specifications
• Notes
UUNNPPAACCKKIINNGG
Included in the packing of your Kandy Integrated Amplifier you will find:
• One mains lead fitted with the correct mains power plug for your country
• One Kandy Integrated Amplifier Remote Handset and AA batteries (x2)
• One information pack and warranty card
After removing these items please retain all packing materials. Correct packing is necessary for future
transportation of your Kandy Integrated Amplifier.
MMAAIINNTTEENNAANNCCEE
After disconnecting the Kandy Integrated Amplifier from the mains supply, the cabinet and front panel may be
cleaned with a lightly dampened soft cloth or chamois leather. Avoid using abrasives or solvents.
EEUU DDIIRREECCTTIIVVEESS
This product is designed to comply with the legal provisions of EU Directives 89/3336/EC and 72/23/EC. The
standards which have been applied are those which were in force at the time of the introduction of this product.
This product bears the CE mark.
This product is compliant to EN 60065.
This product must be earthed. Please ensure that other equipment connected to it is earthed according to the
manufacturer’s instructions.
Roksan Audio ltd Kandy Integrated Amplifier User Manual
CLASSIFICATION: General Use Version 3.3
All specifications are liable to change without notice. E&OE Page 2 of 11 ENGLISH
CAUTIONS Kandy Integrated Amplifier
AACC MMAAIINNSS SSUUPPPPLLYY
Your Kandy Integrated Amplifier is set to operate from a fixed supply voltage which is marked on a label next to
the mains input plug. Before connecting the mains lead please check that your mains supply corresponds to this
label as below:
230V Products ………………………………….Voltage Range: 220V – 240V
115V Products ………………………………….Voltage Range: 100V – 120V
The mains lead supplied with this product has an IEC mains socket which plugs into the IEC connector on the
unit’s rear panel. The other end is normally attached to the appropriate mains plug for your country. In the UK
this is the standard UK13A plug.
This plug should ordinarily not be removed from the lead. If you do remove it, please dispose of it safely so that it
cannot be plugged into a mains socket whilst in a potentially dangerous condition. We suggest that you obtain
from your dealer a complete replacement lead.
Should you move to another area where either the mains voltage or the mains plugs are different from those as
supplied with your Integrated Amplifier, please contact the appointed ROKSAN distributor for assistance.
Please observe correct mains polarity at all times.
The Integrated Amplifier mains fuse is located on the rear panel next to the IEC mains connector. This must only
be replaced by the fuse of the type and rating as described on the fuse rating label on the rear panel of the unit.
This product requires connection to earth (ground). The earth wire (in the UK this is colour coded green/yellow)
of the mains cable supplied with your Integrated Amplifier must be connected to a suitable earthing point
established for this purpose by your electricity supply company. If you are in any doubt, consult a qualified
electrician.
If the equipment is likely to be unused for some time, unplug it from the mains supply.
GGEENNEERRAALL CCAAUUTTIIOONNSS
FCC WARNING
This equipment may generate or use Radio Frequency energy. The user may lose the right to operate this
equipment if unauthorised modifications are made.
INTERFERENCE
Properly installed, this unit should not cause harmful interference to radio communications, There is, however, no
guarantee that such interference will not occur in a specific installation. If interference arises (which you can
determine by switching the unit off and on) you could try to remedy matters by the following:
• Re-orient or re-locate the receiving antenna
• Increase the distance between the Kandy Integrated Amplifier and receiver
• Connect the unit to a different mains circuit from that of the receiver
• Consult your ROKSAN appointed dealer or an experienced Radio/TV technician for help and advice
LOCATION
Your Kandy Integrated Amplifier should be located in a well ventilated area and kept away from sources of heat,
dust and humidity and from direct sunlight.
The Integrated Amplifier may be positioned either as a free standing unit or alongside another audio/video
product.
Never place the Integrated Amplifier on carpet or any surface likely to hinder normal ventilation.
Never allow liquids or other objects to fall into the unit.
This unit contains no user serviceable parts. Do Not remove any panels or attempt to service it yourself.
Unauthorised servicing will void the warranty.
Roksan Audio ltd Kandy Integrated Amplifier User Manual
CLASSIFICATION: General Use Version 3.3
All specifications are liable to change without notice. E&OE Page 3 of 11 ENGLISH
INSTALLATION Kandy Integrated Amplifier
V
RROOKKSSAANN KKaannddyy IInntteeggrraatteedd AAmmpplliiffiieerr-- FFrroonntt PPaanneell VViieeww
2 3 4 5
6 7 8 9 10 1 11 12 13 14
CD TUNERVIDEO LINE 1 LINE 2 PHONO TAPEMODEREMOTE
MODE TAPE
INPUT
ROKSAN
1. Mode Button
2. Input Button (Back)
3. Input Button (Forward)
4. Mode Indicator
5. CD Input Indicator
6. Tuner Input Indicator
7. Video Input Indicator
8. Line 1 Input Indicator
9. Line 2 Input Indicator
10. Phono Input Indicator
11. Tape Monitor Indicator
12. Tape Monitor Button
13. Volume Control
14. Headphone Socket
RROOKKSSAANN KKaannddyy IInntteeggrraatteedd AAmmpplliiffiieerr -- RReeaarr PPaanneell VViieeww
Roksan Audio ltd Kandy Integrated Amplifier User Manual
CLASSIFICATION: General Use Version 3.3
All specifications are liable to change without notice. E&OE Page 4 of 11 ENGLISH
2
1
3 4 17 6 7 8 9 10 5
11
PHONE
OLUME
Integrated Amplifier KA-I MkIII
12 13
14
15
16
Loading...