Rohde&Schwarz R&S®RT-ZF2 Manual User Manual
®
R&S
RT-ZF2
Ethernet Compliance
Test Fixture Set
Manual
(=AÅÁ2)
1317555102
Version 09
This manual describes the R&S RT-ZF2 Ethernet Compliance Test Fixture Set
(1317.5522.02).
© 2021 Rohde & Schwarz GmbH & Co. KG
Mühldorfstr. 15, 81671 München, Germany
Phone: +49 89 41 29 - 0
Email: info@rohde-schwarz.com
Internet: www.rohde-schwarz.com
Subject to change – data without tolerance limits is not binding.
R&S® is a registered trademark of Rohde & Schwarz GmbH & Co. KG.
Trade names are trademarks of the owners.
1317.5551.02 | Version 09 | R&S®RT-ZF2
Throughout this manual, products from Rohde & Schwarz are indicated without the ® symbol, e.g.
R&S®RT-ZF2 is indicated as R&S RT-ZF2.
R&S®RT-ZF2
Safety Information
1 Safety Information
The product documentation helps you to use the product safely and efficiently.
Keep the product documentation nearby and offer it to other users.
Safety information warns you about the potential dangers and gives instructions
how to prevent personal injuries or damage caused by dangerous situations.
Throughout the documentation, safety instructions are provided when you need to
take care during setup or operation.
Intended use
The equipment under test (EUT) is a signal quality test and development board,
indented to be used at laboratory or test and measurement areas. These areas
are used for analysis, testing and servicing and where equipment is operated by
trained personnel.
Operating site
Only use the product indoors, and keep it dry. The product has no casing and is
sensitive to moisture and humidity.
The product is suitable for pollution degree 2 environments where nonconductive
contamination can occur. For more information on environmental conditions such
as ambient temperature, see the specifications.
Installation
Connect only Ethernet devices with RJ-45 interface that are designed according
to 100BASE-T1 IEEE Std 802.3bw™-2015 (Amendment to IEEE Std
802.3™-2015), 1000BASE-T1 (IEEE Std 802.3bp™-2016).
Disposal
In line with EN 50419, the product cannot be disposed of in the normal
household waste. Even disposal via the municipal collection points for
waste electrical and electronic equipment is not permitted.
Rohde & Schwarz has developed a disposal concept for the ecofriendly disposal
or recycling of waste material. Rohde & Schwarz fully assumes its obligation as a
producer to take back and dispose of electrical and electronic waste. Contact
your local service representative to dispose of the product.
3Manual 1317.5551.02 ─ 09
Loading...