Rohde&Schwarz R&S®FSV-B30/-B32/-B34 DC Power Supply and Battery Operation Installation Manual - discontinued options Manual

DC Power Supply and
Battery Operation

R&S FSV-B30/-B32/-B34

Installation Manual

(;ÚÞ02)

1176.8000.02 ─ 02

Installation Manual

Test & Measurement

This installation manual describes the following functions and options:

● DC Power Supply (R&S FSV-B30, Order no. 1310.9897.02)

● Li-Ion Battey Pack (R&S FSV-B32, Order no. 1321.3750.02)

● Battery Charger (R&S FSV-B34, Order no. 1321.3950.02)

© 2013 Rohde & Schwarz GmbH & Co. KG

Mühldorfstr. 15, 81671 München, Germany

Phone: [phone] - 0

Fax: [phone]

E-mail: [e-mail]

Internet: www.rohde-schwarz.com

Subject to change – Data without tolerance limits is not binding.

R&S® is a registered trademark of Rohde & Schwarz GmbH & Co. KG.

Trade names are trademarks of the owners.

The following abbreviations are used throughout this manual: R&S®XXX is abbreviated as R&S XXX.

Contents

1 DC Power Supply...................................................................3

2 Li-Ion Battery Pack and Charger........................................ 12

ContentsDC Power Supply and Battery Operation

Preparing the DC Power Supply

1 DC Power Supply

Using the DC power supply (option R&S FSV‑B30), the R&S FSV can be oper­ated with a DC voltage of 10 V to 15 V.

● Preparing the DC Power Supply....................................................................... 3

● Installing the DC Power Supply.........................................................................4

● Putting into Operation..................................................................................... 10

1.1 Preparing the DC Power Supply

In the factory, the DC Power Supply (option R&S FSV‑B30) is provided with a cig­arette lighter plug (required to connect to older battery packs). Thus, in order to
use the DC Power Supply with the new Li‑Ion Battery Pack (option
R&S FSV‑B32), you must first remove the old plug and replace it by the one pro­vided with the Li‑Ion Battery Pack.

To prepare DC power supplies for installation

1. Remove the DC cable with the cigarette lighter plug from the DC power sup­ply.

2. Connect the new DC cable to the DC power supply as shown in figure 1-1. Be
sure to connect the cables in the correct order!

3Installation Manual 1176.8000.02 ─ 02

DC Power SupplyDC Power Supply and Battery Operation

Installing the DC Power Supply

Fig. 1-1: Connecting the new DC power cable to the DC power supply

Blue = - terminal
Brown = + terminal

1.2 Installing the DC Power Supply

The DC power supply is attached to the rear panel of the R&S FSV.

To install the DC Power Supply on the R&S FSV

1.

Disconnect the power cable from the R&S FSV.

2.

Only for instruments with R&S FSV‑B1 option (ruggedized housing):

4Installation Manual 1176.8000.02 ─ 02

Installing the DC Power Supply

a) Unscrew and remove the corner protectors (1).

DC Power SupplyDC Power Supply and Battery Operation

Fig. 1-2: Removing corner protectors

5Installation Manual 1176.8000.02 ─ 02