®
R&S
Cable Rider ZPH
Handheld Cable and
Antenna Analyzer
Getting Started
(=E9\2)
1321094402
Version 12
This document describes the following R&S®Cable Rider ZPH models with firmware version 1.90 and higher:
●
R&S®ZPH (1321.1211.02)
●
R&S®ZPH (1321.1211.12)
●
R&S®ZPH (1321.1211.52, equivalent to 1321.1211.02)
© 2022 Rohde & Schwarz GmbH & Co. KG
Muehldorfstr. 15, 81671 Muenchen, Germany
Phone: +49 89 41 29 - 0
Email: info@rohde-schwarz.com
Internet: www.rohde-schwarz.com
Subject to change – data without tolerance limits is not binding.
R&S® is a registered trademark of Rohde & Schwarz GmbH & Co. KG.
Trade names are trademarks of the owners.
1321.0944.02 | Version 12 | R&S®Cable Rider ZPH
Throughout this manual, products from Rohde & Schwarz are indicated without the ® symbol , e.g.
R&S®Cable Rider ZPH is indicated as R&S Cable Rider ZPH.
R&S®Cable Rider ZPH
Contents
1 Safety information................................................................. 5
2 Korea certification class B....................................................6
3 Documentation overview...................................................... 7
3.1 Manuals..................................................................................................7
3.2 Data sheet..............................................................................................8
3.3 Calibration certificate........................................................................... 8
3.4 Release notes, open source acknowledgment.................................. 8
3.5 Application notes, application cards, videos.....................................8
Contents
4 Welcome to the R&S Cable Rider ZPH................................ 9
5 Preparing for use................................................................. 10
5.1 Putting into operation.........................................................................10
5.1.1 Unpacking and checking the instrument............................................... 11
5.1.2 Accessory list........................................................................................ 12
5.1.3 Setting up the R&S Cable Rider ZPH................................................... 12
5.1.4 Using the AC adapter............................................................................14
5.1.5 Battery operation...................................................................................15
5.1.6 Battery maintenance............................................................................. 17
5.2 Switching the instrument on and off.................................................18
6 Instrument tour.................................................................... 20
6.1 Front view............................................................................................ 20
6.2 Top view...............................................................................................21
6.3 Left view...............................................................................................25
6.4 Right view............................................................................................ 25
6.5 Rear view............................................................................................. 26
3Getting Started 1321.0944.02 ─ 12
R&S®Cable Rider ZPH
6.6 Display overview.................................................................................26
Contents
7 Contacting customer support............................................ 28
Index..................................................................................... 29
4Getting Started 1321.0944.02 ─ 12
R&S®Cable Rider ZPH
Safety information
1 Safety information
The product documentation helps you use the R&S Cable Rider ZPH safely and
efficiently. Follow the instructions provided here and in the printed "Basic Safety
Instructions". Keep the product documentation nearby and offer it to other users.
Intended use
The R&S Cable Rider ZPH is intended for the development, production and verification of electronic components and devices in industrial, administrative, and laboratory environments. Use the R&S Cable Rider ZPH only for its designated purpose. Observe the operating conditions and performance limits stated in the data
sheet.
Where do I find safety information?
Safety information is part of the product documentation. It warns you about the
potential dangers and gives instructions how to prevent personal injuries or damage caused by dangerous situations. Safety information is provided as follows:
●
The printed "Basic Safety Instructions" provide safety information in many languages and are delivered with the R&S Cable Rider ZPH.
●
Throughout the documentation, safety instructions are provided when you
need to take care during setup or operation.
5Getting Started 1321.0944.02 ─ 12
R&S®Cable Rider ZPH
Korea certification class B
2 Korea certification class B
이 기기는 가정용(B급) 전자파 적합기기로서 주로 가정에서 사용하는 것을 목적으
로 하며, 모든 지역에서 사용할 수 있습니다.
6Getting Started 1321.0944.02 ─ 12
R&S®Cable Rider ZPH
Documentation overview
Manuals
3 Documentation overview
This section provides an overview of the R&S Cable Rider ZPH user documentation.
3.1 Manuals
You find the documents on the R&S Cable Rider ZPH product page at:
http://www.rohde-schwarz.com/manual/zph
Getting started manual
Introduces the R&S Cable Rider ZPH and describes how to set up and start working with the product. The printed document is delivered with the instrument.
User manual
Contains the description of all instrument modes and functions. It also provides
an introduction to remote control, a complete description of the remote control
commands with programming examples, and information on maintenance and
instrument interfaces. Includes the contents of the getting started manual.
The online version of the user manual provides the complete contents for immediate display on the internet.
Basic safety instructions
Contains safety instructions, operating conditions and further important information. The printed document is delivered with the instrument.
Instrument security procedures manual
Deals with security issues when working with the R&S Cable Rider ZPH in secure
areas.
Service manual
Describes the performance test for checking the rated specifications, module
replacement and repair, firmware update, troubleshooting and fault elimination,
and contains mechanical drawings and spare part lists. The service manual is
7Getting Started 1321.0944.02 ─ 12
R&S®Cable Rider ZPH
Application notes, application cards, videos
available for registered users on the global Rohde & Schwarz information system
(GLORIS, https://gloris.rohde-schwarz.com).
Documentation overview
3.2 Data sheet
The data sheet contains the technical specifications of the R&S Cable Rider ZPH.
It also lists the options and their order numbers as well as optional accessories.
The brochure provides an overview of the R&S Cable Rider ZPH and shows its
specific characteristics.
http://www.rohde-schwarz.com/brochure-datasheet/zph
3.3 Calibration certificate
The document is available on https://gloris.rohde-schwarz.com/calcert. You need
the device ID of your instrument, which you can find on a label on the rear panel.
3.4 Release notes, open source acknowledgment
The release notes list new features, improvements and known issues of the current firmware version, and describe the firmware installation.
The open source acknowledgment document provides verbatim license texts of
the used open source software.
http://www.rohde-schwarz.com/firmware/zph
3.5 Application notes, application cards, videos
These documents contain information about possible applications and background information on various topics, see www.rohde-schwarz.com/appnotes
8Getting Started 1321.0944.02 ─ 12
R&S®Cable Rider ZPH
Welcome to the R&S Cable Rider ZPH
4 Welcome to the R&S Cable Rider ZPH
The R&S Cable Rider ZPH is a new generation Rohde & Schwarz cable and
antenna analyzer developed to meet demanding customer requirements. Offering
touchscreen input, the analyzer enhances user experience in making measurements fast and easy.
This user manual contains a description of the functionality that the instrument
provides. The latest version is available for download at the product homepage
(http://www.rohde-schwarz.com/product/zph.html).
9Getting Started 1321.0944.02 ─ 12
Loading...