Rockwell Collins 2703240 User Manual

Vehicle Repeater System Module

Installation Manual

Vehicle Repeater System Module

270-3240-020

Installation Manual

Proprietary Notice

NOTICE: The contents of this document are proprietary to Rockwell Collins, Inc. and
shall not be disclosed, disseminated, copied, or used except for purposes expressly
authorized in writing by Rockwell Collins, Inc.

Export Notice

The technical data in this document (or file) is controlled for export under the Export
Administration Regulations (EAR), 15 CFR Parts 730-774. Violations of these export
laws may be subject to fines and penalties under the Export Administration Act.

© Copyright 2009 Rockwell Collins, Inc. All rights reserved.

Prepared by: Approved by:
_________________________

________________________
Dave Philipp Date Deborah Braid Date
System Engineer Technical Project Manager

Approved by: Approved by:
_________________________

________________________
Cris Johnson Date Jason Heimer Date
Engineering Manager Program Manager

Rockwell Collins, Inc. – Proprietary Information.

i

Vehicle Repeater System Module

Installation Manual

This page is intentionally left blank.

Rockwell Collins, Inc. – Proprietary Information.

ii

Vehicle Repeater System Module

Installation Manual

FCC COMPLIANCE

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:

1. This device may not cause harmful interference

2. This device must accept any interference received, including interference that may
cause undesired operation.

WARNING: For compliance with FCC RF Exposure Requirements, the mobile transmitter
antenna installation shall comply with the following two conditions:

1. The transmitter antenna gain shall not exceed 3 dBi.

2. The transmitter antenna is required to be located outside of a vehicle and kept at a
separation distance of 10 inches or more between the transmitter antenna of this
device and persons during operation.

WARNING: CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY
ROCKWELL COLLINS COULD VOID THE USER'S AUTHORITY TO OPERATE
THE EQUIPMENT.

Note: This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.

Note: If the FCC ID is not visible when the module is installed inside another device, then
the outside of the device into which the module is installed must also display a label
referring to the enclosed module. This exterior label can use wording such as the following:
"Contains Transmitter ModuleFCC ID: XEU2703240" or "Contains FCC ID: XEU2703240."

CAUTION

This unit contains static sensitive dev ices. Wear a grounded wrist strap and/or conductive
gloves when handling printed circuit boards.

Rockwell Collins, Inc. – Proprietary Information.

iii

Vehicle Repeater System Module

Installation Manual

TABLE OF CONTENTS

1.0 General Description........................................................................................ 1

1.1 Scope ....................................................................................................... 1

1.2 Technical Characteristics.............................................................................. 1

1.3 Environmental Testing Summary................................................................... 1

2.0 Interface Control Drawing ............................................................................... 2

2.1 Definitions ................................................................................................. 2

2.2 P25 Vehicle Repeater System Interface Definition............................................ 3

2.2.1 P25 VRS Antenna Connectors................................................................. 4

2.2.2 P25 VRS DB-44 Connector..................................................................... 4

3.0 Installation Control Drawing ............................................................................ 6

4.0 Acronyms ..................................................................................................... 8

Rockwell Collins, Inc. – Proprietary Information.

iv

Vehicle Repeater System Module

Installation Manual

LIST OF FIGURES

Figure 1 – ICD Drawing Key ...................................................................................... 2

Figure 2 – P25 VRS System Connection....................................................................... 4

Figure 3 – P25 VRS TNC Antenna Connector (Dims in mm) ............................................ 4

Figure 4 – P25 VRS SMA Antenna Connector (Dims in mm)............................................ 4

Figure 5 – P25 VRS DB-44 Connector.......................................................................... 5

Figure 6 – P25 VRS Outline Drawing (dims in inches) .................................................... 7

Rockwell Collins, Inc. – Proprietary Information.

v