TAILGATE TABLE INSTALLATION
AC-TB-100-JTY, AC-TB-101-JTY
NOTE: The Tailgate Table and Large Tailgate Table can be mounted to any flat surface. These
instructions will show installation on a Wrangler tailgate, but the same procedures will apply to
install to the flat area of your choice.
Rock Slide Instruction RSEI 121
Parts List
Insert small part
of captive pin
through the inside
of table top
Large half of
captive pin on
the outside of
table top
1-Tailgate Table
6-Self-Tapping machine screws
2-Captive Pins
1-Rubber strip
TAILGATE TABLE INSTALLATION
1. Attach the Captive Pins to your Tailgate Table. These pins hold your tailgate
together when it is in the closed position
a. The pins have two parts to each side. The small piece slides from the inside
of the table top and the large piece screws on the small piece with the table
top sandwiched between the pieces
Captive Pins
2. Choose the location to mount your Tailgate Table
3. If mounting on a Jeep JK Model, some of the black plastic trim covering the 3
light wires on the tailgate will need to be removed
rd
brake
Rock Slide Instruction RSEI 121
Hold the tailgate table to desired spot and
mark where the plastic trim needs to be
cut. Ensure the tailgate table is high
enough to clear the cargo tray
Cut the plastic
piece to allow the
tailgate table to sit
flat on the tailgate
Mounting points
4. With the tailgate table folded open, hold it in the desired position and screw it into
the tailgate. There are six holes for mounting and 6 screws provided
5. A rubber strip is provided to hold the table together tighter and ensure it does not
rattle. The rubber strip is attached to the front lip of the bottom table surface.
Rock Slide Instruction RSEI 121
Rubber strip
Front edge of bottom
table surface
6. The rubber strip can be customized. The entire strip can be put on the edge or cut
the rubber into put smaller pieces on if you don’t want the fit to be as tight. The
strip is pushed onto the edge of the metal
Rubber strip installed
7. The table is folded up by folding in this order:
a. Bottom table is folded in half and put at the back
b. Fold right arm in against bottom table
c. Fold left arm in against right arm
d. Fold top table down
e. Rotate capture pins clockwise until they push in to lock table together
8. To open the table, turn capture pins counterclockwise and pull out. Fold table out in
this order:
a. Lift table top up
b. Pull left arm out
c. Pull right arm out
d. Fold bottom table out and click table surface into the slots on both arms
Rock Slide Instruction RSEI 121
Slots on side arms
Thank you for choosing Rock-Slide Engineering products. We value your business and
welcome your feedback/suggestions. If you have any concerns please contact us directly @
435-752-4580. We are here to help you!
Rock Slide Instruction RSEI 121
Loading...