Rock-Slide Engineering Rigid Rack User Manual

Rigid Rack Installation Instruction

QTY

DESCRIPTION

1

Rigid Rack

2

U-Bolts

4

Nuts and washers

AC-RR-102

Parts List

*If any parts listed are missing or damaged please call Rock-Slide Engineering @

435-752-4580 prior to installation

Installation Instruction RSEI 127

U Bolts installed from
the bottom up

Rigid Rack Installation

1. The Rigid Rack is specifically designed to attach to the Tire Arm Carrier of the Rock-

Slide Engineering Rear Bumper with Tire Carrier. It could however be mounted to any
2” wide, 45 degree angle swing arm carrier

2. Set the Rigid Rack on the Tire Arm Carrier in the desired position. Ideal location is

close to the spare tire without touching the spare

3. Run the U bolts from the bottom of the tire carrier arm up to the holes on the Rigid

Rack. You may have to pull the U bolts apart to make the wide enough to fit into the
holes

4. Attach the both U Bolts with the washer and nut. Alternate tightening both sides of

the U bolt to ensure it tightens evenly

5. The Rigid Rack has mounting holes for a variety of attachments. Possibilities include:
a. Rock-Slide Engineering Jack and Shovel Mount (part # AC-HIS-100, comes with

two brackets for a top and bottom mounting security)

b. Roto-Pax can system

Installation Instruction RSEI 127
Jack and shovel
mount pair