Ford F-150/Raptor Spare Tire Carrier
AC-STC-RS, AC-STC-RA
Installation Instruction RSEI 134
PARTS LIST
QTY
DESCRIPTION
1
Carrier Body
1
Front Legs
1
Back Legs
1
Rubber Bump Stop, nut,
bolt 1 RSE Star
1
Threaded Post
2
¾” washers
2
¾” nuts
5
7/16” bolts
10
7/16” washers
5
7/16 nuts
2
Large painted washers
*If any parts listed are missing or damaged
please call Rock-Slide Engineering @
435-752-4580 prior to installation
INSTALLATION
1. Attach the two sets of legs to the spare tire carrier body using the 7/16”
bolts, nuts and washers.
2. Screw rubber bump stop into hole at narrow end of the carrier with the nut
and washer. (this protects the bed when weight of spare tire is on carrier.)
Installation Instruction RSEI 134
3. Attach the threaded post to the body. The end with the hole goes at the top
of the carrier for the padlock. The post is long so you can adjust it for the size
of your spare tire wheel. Leave enough post out the top of the carrier for
your spare tire and the Rock Slide Star that holds your tire in place. Attach
the post underneath the carrier with the large round painted washer, then
the ¾” washer, then tighten with nut (see below). On the top of the carrier,
tighten the post to the carrier with a ¾” washer and nut. Tighten both nuts
to sandwich the post on the carrier body.
4. Set the assembled Spare Tire Carrier in the bed of the truck. The carrier
attaches to the bed using factory bolts. Set in position (as pictured below).
You can then determine which of the factory bolts need to be removed to
attach the carrier.
5. Remove the four applicable factory bolts to be used to attach the carrier. The
nuts are underneath the bed. Take the nuts and washers off (keep to be
reused) and push the bolts up through the bed. Remove all the way in the
bed (keep to be reused).
6. Attach the spare tire carrier to the bed using at the four spots with the
removed bolts. Push the carriage bolts through the spare tire carrier, and
Installation Instruction RSEI 134
through the bed. Reattached the nuts and washers underneath the bed.
Tighten all bolts.
7. Set spare tire on carrier with the post going through the center of the tire.
8. Put large black painted washer onthe post and lay on spare tire. Turn the
Rock Slide Star onto the post and onto the washer on spare tire.
9. Use a padlock of your choice to secure star to post.
Thank you for choosing Rock-Slide Engineering products. We value your business and welcome your
feedback/suggestions. If you have any concerns please contact us directly @ 435-752-4580. We are
here to help you!
Installation Instruction RSEI 134
Loading...