Rock-Slide Engineering PATRIOT SERIES – REAR BUMPER User Manual

QTY

DESCRIPTION

1

Patriot Rear Bumper

6

5/16'' Bolts

6

5/16'' Nuts

12

3/8'' Washers

Ford F-150/Raptor Patriot Rear Bumper

RB-F-101-RA

PARTS LIST

*If any parts listed are missing or damaged please call Rock-Slide Engineering @

435-752-4580 prior to installation

PATRIOT REAR BUMPER INSTALLATION

License Plate Lights Spare Release Lock

Back Up Sensors

Bolt Placement

1. Remove factory bumper.

2. Install Anzo lights using manufacturers hardware/brackets before mounting the R-SE Patriot.

3. Connect spare release lock into its respective hole.

4. Connect license plate lights into their respective holes.

5. Connect back up sensors into their respective holes.

6. Mount the R-SE Patriot into its proposed position making sure its level and even on both sides.
a. You might want help doing this to position R-SE Patriot evenly

7. Using 1/2’’ wrench/socket secure the R-SE Patriot onto the Raptor frame.
a. 6 5/16’’bolts, 12 3/8’’ washers, 6 5/16’’ nuts
b. You will be using 1 bolt, 2 washers, and 1 nut per mount

i. Sequence= bolt - washer - bumper - washer – nut

c. We recommend fastening top 4 bolts first, then bottom 2

8. Put final tightening on all bolts to make sure R-SE Patriot rear bumper is fully secure.

Thank you for choosing Rock-Slide Engineering products. We value your business and welcome your
feedback/suggestions. If you have any concerns please contact us directly @ 435-752-4580. We are
here to help you!