Rock N Roller R14G User manual

R14G Model Specifications

Length (Compact) 42” 2 x ½” lock nuts

Length (Extended) 60” 2 x ½” at washer
Width (Frame Bed) 15” 2 x 1/8” x 1 ¼” cotter pins

Width (Rear Wheels) 20” 2 x 20mm flat washers

Height (Folded) 10” 2 x 8"x 3" (200mm x 75mm) rear wheels

Height (Unfolded) 38” 2 x 6"x 3" (150mm x 75mm) stem casters

Front Casters 6” x 3” 1 x Flat Wrench

Rear Wheels 8” x 3” 1 x Assembly/instruction sheet

Weight 36 lbs.

Load Capacity 700 lbs.

Your RocknRoller Multi-Cart shipping box should
contain a frame and the following parts:

Recommended Tools For Assembly

Channel Lock Pliers

(not included)

1. Installing Rear Wheels

Gently slide wheel over axle as shown.
Do not force wheels onto axle. It is
recommended to lubricate axles with light
grease before installing. Install cotter pins
and bend ends outward.

2. Installing Front Swivel Casters

Attach front swivel casters as shown. While tightening lock nuts, grip
bearing cap with channel lock pliers or pipe wrench to prevent threaded
stem from turning. Tighten lock nuts rmly, but not excessively tight.
Check lock nut tightness on caster stems periodically.

Extending Frame

Raising Foldable Sides

Solid Deck

Cable/headphone

hanger

Loosen wingbolts 1/4 turn. Step on
rear axle and push in extension
stop button. Pull up on frame as
shown until stop button engages.
Retighten wingbolts.

Laptop Shelf Flex Straps

Firmly press down on release cable
while raising other end of foldable
side as shown.

Repeat with other side.