RocketFish RF-BTAPDT User Manual

Bluetooth 2.0 EDR Class II Wireless
USB Adapter

RF-BTAPDT

User Guide

Rocketfish RF-BTAPDT

Bluetooth® Wireless

USB Adapter

Contents

Introduction ................................................................. 2

Features ......................................................................... 2

Using the Bluetooth adapter ................................. 3

Troubleshooting.......................................................11

Legal notices ..............................................................13

Introduction

Congratulations on your purchase of the RF-BTAPDT
Bluetooth® adapter. This Bluetooth adapter lets you connect
any wireless Bluetooth device to any computer that has an
available USB port.

Features

• Supports Bluetooth devices

• Bluetooth specification v1.2 and v2.0 compliant

• Compatible with the following profiles:

• Generic Access Profile (GAP)

• Generic Object Exchange Profile (GOEP)

• Serial Port Profile (SPP)

• File Transfer Profile (FTP)

• Object Push Profile (OPP)

• Dial-up Networking Profile (DUN)

2

• Synchronization Profile (SYNC)

• Fax Profile (FAX)

• Personal Area Networking Profile (PAN)

• Human Interface Device Profile (HID)

• Headset/Audio Gateway Profile (HSP)

• Hardcopy Cable Replacement Profile (HCRP)

• Basic Imaging Profile (BIP)

• Basic Printing Profile (BPP)

• Generic Audio Video Distribution Profile (GAVDP)

• Advanced Audio Distribution Profile (A2DP)

• Audio Video Remote Control Profile (AVRCP)
Refer to the device’s user guide for additional
instructions and security codes.

Package contents

• Bluetooth® Wireless USB Adapter

•Installation CD

•User Guide

System requirements

• Intel® Pentium® processor (or equivalent)

• One available USB port (USB 2.0 or 1.1)

•CD drive

• Operating system: Microsoft® Windows® XP with Service
Pack 1 or higher, or Microsoft® Windows® 2000

Using the Bluetooth adapter

Installing the Bluetooth software

This procedure assumes you’re installing the software onto a
Windows XP computer.

RF-BTAPDT

3

To install the Bluetooth software:

1 Plug the Bluetooth adapter into an available USB port on

your computer. If you forget to connect the adapter to
your computer before installing the software, a warning
message will appear during the software installation.

2 Insert the provided installation CD into the CD drive on

your computer. The Bluetooth installation program runs
automatically, and the Welcome dialog box opens.

If the program doesn’t start automatically, open
Windows Explorer and run the file setup.exe on the
installation CD.

3 Click Next.
4 Read the agreement, click I accept the terms in the license

agreement, then click Next. A dialog box opens that shows

you where the program will be installed to.

5 To install the program to a different location, click Change,

then type the correct location.

6 Click Next.
7 Click Install. The program is installed.

4

8 When the “Driver Signature Notice” message appears,

click OK.

9 If the “Bluetooth device not found” message appears,

plug the Bluetooth adapter into an available USB port,
then click OK.

The Found New Hardware Wizard installs software for
the USB Bluetooth adapter. Installation may take several
minutes.

Setting up the Bluetooth software

To configure the Bluetooth software:

1 Double-click My Bluetooth Places on the Windows desktop,

or click the Bluetooth icon in the system tray.

The Initial Bluetooth Configuration Wizard starts.

RF-BTAPDT

5