Robinhood ST9001W, ST9001WA Installation Manual

1

Description: ROBINHOOD SUPERTUB WORKSTATION

Model Number: ST9001W / 9001WA

Model pictured: ST90001W/ST9001WA

ST9001W

Issue: 2

All dimensions in mm
Model may vary slightly from images pictured

2

Overview

Contents of packaging:

1 x Robinhood Supertub (incl waste system, plug)

1 x Installation kit (incl feet)

1 x Tap ware (incl flexible hoses, support plate, fixing plate, nuts) 2 x Handles, washers and screws.

Pre-installation

Important:

o Please read the entire instructions before installing the laundry tub.

o Ensure the household pipes are thoroughly flushed to remove debris before connecting your laundry tub to

the pipe works. To prevent foreign particles damaging the ceramic cartridge an „in-line‟ filter is
recommended to be installed prior to the mixer.

o Warranty on single lever mixer is void if the in-line filter is not fitted.

o Recommended temperature range 5° to 65°C. Maximum temperature 80°C.

o Maximum pressure 174 PSI (1200 kPa), minimum pressure 10 PSI (70 kPa).

Regulation compliance

Comply with current Drainage and Plumbing Regulations as required by your local authority. Sanitary
plumbing shall only be carried out by a Registered Plumber. All plumbing work must be done in accordance
with local and national building and plumbing codes as applicable. All electrical work must be done in
accordance with local and national electrical codes as applicable. In some instances this product may need to

be earthed.

Determine site

Determine the most suitable position for the laundry tub. It may be used either to the left or right of the
washing machine. Allow 10mm clearance between the units. Mark the position on the floor as reference.

Important safety information

o This Robinhood Supertub is not intended for use by young children or infirm persons without supervision.

o Young children should be supervised to ensure that they do not play with the Robinhood Supertub.

o Use abrasive household cleaner.

3

Installing the Supertub

Confirm if the washing machine waste inlet needs to be moved from right to left before securing the unit to
the wall. If they do need to be changed see page 6 of these installation instructions.

1. To ease installation, remove all three drawers, handles and washing machine hose. To remove a drawer,

simply slide the drawer out to its full extent, lift the front and pull to remove.

2. Fit the four adjustable feet supplied to the

bottom of the cabinet and adjust to align with
worktop or washing machine height. Use the
lock nut to secure the feet into position. Tilt
laundry tub slightly to assist with access. Check
the top of the laundry tub with a spirit level to
ensure that it is level and check that the cabinet
does not “rock”. Replace the drawers and check
that they operate correctly and are flush fitting, if
not, re-adjust until they are correct. Remove
drawers and continue with the installation.

Locknut Bottom of the unit

3. Line up the laundry tub to the installation and confirm enough room, if necessary remove the skirting

board at the require distance 1200 mm this will allow the unit to sit flush against the wall. (Check with
your local council for building regulations). Remove the laundry tub away from the wall.

4. Fit the black rubber waste

hose protector along the edge
between the waste hose and
the internal bracket.

5. Fit the tap ware to the tub

using the supplied fittings.
Fasten nut securely, ensuring
the plastic fixing piece is in the
correct position.

6. Connect the two flexible hoses

onto the body of the tap ware
from the underside; ensure
that the flexible hoses are
fitted to the hot and cold
correctly. Hand tightened and
then finished with a quarter
turn only.

Hot water
hose only