Robinhood RWC3CL6WHA User Manual

1

Description: ROBINHOOD WALL CANOPY
Model Numbers: RWC3CL6SS, RWC3CL9SS, RWC3CL6WHT, RWC3CL9WH

Model pictured: RWC3CL6SS/WH

RWC

Issue: O

All dimensions in mm
Model may vary slightly from images pictured

2

Pre-installation

Thank you for purchasing a quality Robinhood rangehood. Robinhood has a high standard of quality control
and every rangehood is tested and approved before it leaves the factory.

Important:

Please read the entire instructions before installing the rangehood.

Always switch power off prior to installation.

All electrical work must be done in accordance with local and national electrical codes as applicable.

For safety, this product must be earthed.

A power outlet should be within 1000mm of the power cord exit from the rangehood.

The socket must be accessible and enable the end user to isolate the rangehood from the power for the
purpose of internal cleaning or maintenance.

Stainless steel or powder coat is very easily damaged during installation if abraded or knocked by tools.
Protect the rangehood with the cardboard box or plastic bag during installation.

All ducting must comply with local requirements and building codes.

Suitable fixings will be required to mount this rangehood.

See Ducting options next page.

Note that Accessible parts may become hot when used with cooking appliances.

Contents of packaging:

1 x rangehood
1 x 150mm ducting adaptor
1 x packet of fasteners and wall plugs
2 x chimney pieces (upper and lower)
2 x chimney bracket
1 x fixing plate

Typical equipment required:

o electric drill
o screwdriver
o tape measure
o spirit level
o duct tape (if ducting)
o jig saw and ladder(if ducting)

3

Pre-Installation - continued

Ducting Options

The method of ducting should be carefully considered before installing the rangehood. The guide below
recommends the ducting components to use for all common ducting configurations - through the top of the home
(for the roof and soffit) and through the rear of the home. 150mm round ducting should be used in conjunction
with this model rangehood. Alternatively this rangehood can be operated in recirculation mode (see Recirculation
mode pg 6).

The highlighted area in the table below gives the recommended Uniduct item numbers for different
mounting and outlet options.

Duct mounting option

Rear

Top (roof)

Top (soffit/eave)

Uniduct item numbers

150mm

diameter round outlet

1688

1634 and

1635

1634 and

1688

Figure 2.
Extra lengths and/or bends may be required, depending on the length required and whether there is any

structural material in the run e.g. rafters.

Please note that this chart is designed as a guide. Please consult Robinhood customer services if unsure.
For NZ phone [phone] or www.robinhood.co.nz. For AUS phone [phone] or www.robinhood.com.au.