Robinhood IC1300 User Manual

1

Description: ROBINHOOD IRONING CENTRE

Model Number: IC1300

Model pictured: ICI300

IC1300

Issue: 3

All dimensions in mm
Model may vary slightly from images pictured

2

Overview

Contents of packaging:

1 x Robinhood Ironing Centre 1 x Handle

1 x Installation kit (incl screws, magnetic catch. etc.) 1 x Ironing Board Cover

1 x Door

Pre-installation

Important:

o Please read the entire instructions before installing the Ironing Centre.
o Robinhood Ironing Centre can be mounted in two ways: Recessed Mount and Surface Mount. For Surface Mount

the addition of a decorative surface mounting collar is recommended (Product Code ICSMK).

o Remove the Packing Stops with the small flat screwdriver from the Ironing Board assembly.
o Ascertain from the user the DESIRED HEIGHT of the Ironing Board when in the open position.
o We recommend an ironing surface height of 830mm above the floor for an average adult. To obtain this surface

height, the height of the unit (see diagram below) must be 680mm above the floor.

o 830mm is based on the second or middle position of the ironing board.

3

Mounting the Ironing Centre

SURFACE MOUNT OPTION

o Make sure sold timber studs or mounting points are in suitable position for the mounting of the ironing centre.
o Due to many different installation possibilities no holes have been provided for these screws, Robinhood

suggest making 6 holes of suitable diameter for fixing to the customers preferred location. (it may be
necessary to purchase different length screws and/or wall anchors for correct fitting).

NOTE: Surface mounting Kit (Product Code ICSMK) is also available.

RECESS MOUNT OPTION

SIZE OF WALL OPENING

1. The Ironing Centre is designed to fit between 362mm studs. Take out a section of the wall and insert

two timber studs vertically at 362mm apart.

ATTACH BRACE

2. Attach horizontal brace (noggin) between the studs at the desired heights above and below the unit.

Ensure that the braces are level and the top brace is cut to allow the electrical plug and wire to pass
through.

MOUNT CABINET

3. Lift cabinet into place, rest the cabinet on horizontal brace, plumb and shim cabinet to fit, and attach

to studs using the supplied six screws. Mounting hole position are indicated by the arrows. Remove
the electrical wire cover to access mounting hole on the right hand side.

Note - Be sure to allow for wall covering thickness behind cabinet face frame.