
SRCD970
Stereo CD Radio
Cassette Recorder
Please read this manual before use

1. Tone control
2. Headphone socket
3. Tape/Radio/CD Function
switch
4. Volume control
5. Telescopic aerial
6. CD lid
7. CD repeat button
8. CD stop button
9. CD play/pause button
10. CD mix button
11. CD track F Skip and B Skip
buttons
12. CD compartment open button
13. FM stereo indicator
14. Waveband switch
15. Tuning scale
16. Tuning control
17. Liquid crystal display
18. Pause button
19. Stop/eject button
20. Fast forward button
21. Rewind button
22. Play button
23. Record button
24. Cassette door
10
11 12 14 15
16
13
17
18

If you need any further advice, please
call our Technical Helpline on
0181 758 0338 (Mon-Fri)
Batteries
Remove the battery cover on the rear of the unit by pushing the catches in
the direction of the arrows. Insert eight IEC size LR20 batteries (D size) into
the compartment. Take care to ensure all batteries are inserted with the
correct polarity as shown inside the battery compartment. Replace the
battery cover.
Reduced power, distortion, and a 'stuttering' sound are all signs that the
batteries may need replacing.
We would recommend for economy, that the SRCD970 is used on the
mains whenever possible with battery operation for occasional or
stand-by use only.
Automatic Mains/Battery switching
To change from battery to mains operation, simply plug the mains lead into
the mains input socket on the rear of the unit. The batteries will be
automatically disconnected. It does not matter which way round the plug is
inserted but make sure it is fully pushed home. The other end should be
plugged into a domestic supply socket.

If you need any further advice, please
call our Technical Helpline on
0181 758 0338 (Mon-Fri)

If you need any further advice, please
call our Technical Helpline on
0181 758 0338 (Mon-Fri)

Cleaning the Heads
The binder and oxide from magnetic tapes can accumulate on the pinch
roller (A) the capstan shaft (B) and also the heads (C and D). This will impair
the sound quality.
To clean these parts proceed as follows:-
1. Turn off the power to the unit.
2. Press the Stop/Eject button (19).
3. Press the Play button (22) and the heads will be clearly seen.
4. Clean the surfaces (A, B, C, D) with a lint free rag or cotton swab soaked
in alcohol. Press the stop/eject button as soon as cleaning is over.

If you need any further advice, please
call our Technical Helpline on
0181 758 0338 (Mon-Fri)

Disc player
Laser wavelength 780nM
Laser power 5mW max
Frequency response 20Hz-20kHz +2db -2dB
Radio
Frequency Coverage
FM 87.5 -108MHz
MW 530 - 1605kHz
Aerial System FM Telescopic aerial
MW Built-in Ferrite aerial
Imported by:-
PO BOX 130
MEXBOROUGH
SOUTH YORKSHIRE
S64 8YT

If you need any further advice, please
call our Technical Helpline on
0181 758 0338 (Mon-Fri)