Roberts 10-35 Owner's Manual
8 in. Laminate Cutter
OWNER’S MANUAL
Coupeur de plancher
lamellé de 200 mm
MANUEL D’UTILISATION
Cortador de 200 mm
para pisos laminados
MANUAL DE OPERACIÓN
10-35
WARNING Read and understand all
instructions. SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE.
AVERTISSEMENT Lire et comprendre toutes
les directives. VEUILLEZ CONSERVER CES
DIRECTIVES POUR RÉFERENCE ULTÉRIEURE.
ADVERTENCIA Lea y comprenda todas las
instrucciones. GUARDE ESTAS INSTRUCCIONES
PARA USAR COMO REFERENCIA EN EL FUTURO.
WARNING
• Always wear safety glasses when operating this tool
• Keep cutting blade in the fully closed position when not in use
• Keep fingers and hands away from blade cutting area
• Periodically check that all hardware remains tight
1. Assemble handle (G) to the cutting blade (2) with the provided screws (H),
washers (F) and locknuts (E) as shown in the parts diagram.
2. Assemble the blade (2) to the cutter base (I) using the two nylon spacers (1 and 3)
and double threaded shaft (D) as shown in the parts diagram.
1. Place cutter on the floor making sure it is on a level surface.
2. Mark the work piece to be cut and insert it against the
backstop. The “V”-Support (L) should be used to support
the laminate while cutting.
3. Always cut laminate with the finished side up. Place the
grooved or indented side of the laminate against the
backstop. (The "tongue" side should be closest to the
blade.) Begin the cut by holding the laminate firmly with
one hand and cutting into the laminate with the blade
approximately 1/2 in. You now have started your cut.
Proceed using both hands with a smooth powerful
downward motion to complete your cut.
4. Remember the cut side will always be placed along the wall to
be covered up by baseboard or finish molding.
• Keep cutter clean and store in a dry place when not in use
• Keep edges of blade sharp by using a sharpening stone
• Periodically check all assembly to ensure that hardware remains tight
SAFETY WARNINGS FOR 10-35 LAMINATE CUTTER
OPERATING INSTRUCTIONS
MAINTENANCE
ASSEMBLY INSTRUCTIONS FOR 10-35
LAMINATE CUTTER
ROBERTS 10-35
LAMINATE CUTTER
EXPLODED DIAGRAM
Part Description
A Blade Assembly
1- Right Plastic Spacer
2- Cutting Blade
3- Left Plastic Spacer
B Locknut M10
C Washer Ø10
D Axis M10
E Locknut M6 (4)
F Washer Ø6 (8)
G Plastic Nut
H Washer
I Hook
J Screw M6x17 (3)
K Plastic Handle
L Steel Handle
M Screw
N Rubber Mat
O Cutter Base
P Bulkhead (4)
Q "V" Support
Loading...