RLE T120D User Manual
VERIS INDUSTRIES
™
environmental SenSorS
NOTICE
• This product is not intended for life or safety applications.
• Do not install this product in hazardous or classified locations.
• Read and understand the instructions before installing
this product.
• Turn off all power supplying equipment before working on it.
• The installer is responsible for conformance to all applicable codes.
inStallation GUiDe
T SerieS T SerieS
Temperature Transmitters
Installer’s Specifications
TDDA
TWxA/TW
Product IdentIfIcatIon
Output
TDDA
M = 4-20mA
V = 0-5/10VDC
Output
TOA
M = 4-20mA
V = 0-5/10VDC
Local Display
TW A
L = LCD
X = No
Range
1 = -40° to 50 ° C
(-40° to 122°F )
2 = 0° to 50°C
(32° to 122°F)
Range
1 = -40 to 50° C
(-40° to 122°F )
2 = 0° to 50°C
(32° to 122°F)
Sensor Type
= Transmitte r
selec table
output s
Cal Certificate
0 = None
1 = 1 point Cal v alidation
2 = 2 point Cal v alidation
Cal Certificate
0 = None
1 = 1 point Cal v alidation
2 = 2 point Cal v alidation
Setpoint/Override
0 = None
2 = 1k Setpoint
3 = 10k Setpoi nt
4 = 1k Setpoint w ith override
5 = 10k Setpoi nt with override
TOA
Cal Certificate
0 = None
1 = 1 point Cal v alidation
2 = 2 point Cal v alidation
Input Power 4-20mA version - Loop powered 12-30VDC only, 30mA max;
0-5/0-10V versions - 12-30VDC/24VAC, 15mA max
Temp Output 2-wire, loop powere d 4-20mA or 3-wire, 0 -5V/0-10VDC
(switch selectable in T WxA)
Sensor Type Solid-st ate, integrated circuit (Transmi tter)
Accuracy ±0.5°C (±1°F) typical
Ranges 0° to 50°C (32° to 122°F), -40° to 50°C (-40° to 122°F)
Wiring (TOA and TDDA) 22AWG; 2-wire: 4-20mA;
3-wire: Voltage output models
quIck Install
TDDA
Drill a hole in the duct.1.
Insert the temperature probe, until the junction box is flat against the outer 2.
surface of the duc t.
Use screws to secure the junction box to the duct.3.
Wire as shown (see Wiring sec tion).4.
TOA
Locate sensor in an outside area, out of direct sunlight (e.g. under an eave, north 1.
side of building).
Mount the housing. 2.
Wire as shown (see Wiring sec tion).3.
TWxA and TW
Mount the housing vertically on an interior wall in the area to be monitored, in 1.
a location where air circulates freely. Locate unit away from air outlets, corners,
exterior walls, windows, and doors.
Wire as shown (see Wiring sec tion).2.
Local Display
Sensor Type
Setpoint/Override
TW
L = LCD
X = No
Z2 01986 -0 N PAGE 1 ©2010 Veris Industries USA 800.354.8556 or +1.503.598.4564 / support@veris.com 04101
Alta Labs, Enercep t, Enspector, Hawkeye, Trustat, Veris, and the Veris ‘ V’ logo are trademark s or registered tradema rks of Veris Industries, L.L .C. in the USA and/or othe r countries.
B = 100R platin um, RTD
C = 1k platinum, RTD
D = 10k T2, Therm istor
E = 2.2k, Ther mistor
F = 3k, Therm istor
G = 10k CPC, Ther mistor
H = 10k T3, Thermi stor
J = 10k Dale, Ther mistor
K = 10k w/11k shunt,Thermistor
M = 20k NTC, Ther mistor
N = 1800 ohm, Ther mistor
P = 10mV/°C, Linitemp
R = 10k US, Thermis tor
S = 10k 3A221, Thermis tor
T = 100k, The rmistor
0 = None
2 = 1k Setpoint
3 = 10k Setpoi nt
4 = 1k Setpoint w ith override
5 = 10k Setpoi nt with override
Cal Certificate
0 = None
1 = 1 point Cal v alidation
2 = 2 point Cal v alidation
VERIS INDUSTRIES
™
t SerieS
1.2"
(30 mm)
3.5"
(89 mm)
4.8"
(121 mm)
4.6"
(116 mm)
9.3"
(237 mm)
0.9"
(22 mm)
2.8"
(71 mm)
3.4"
(86 mm)
3.9"
(100 mm)
8.5"
(216 mm)
0.5" Dia.
(13 mm.)
4.6"
(116 mm)
2.8"
(71 mm)
3.4"
(86 mm)
3.9"
(100 mm)
POWER SUPPLY
12 To 30 VDC
DIGITAL CONTROL
Temperature
0-10V
+
–
–
Veris #PS-24
0-5V
RED
BLACK
ORANGE
YELLOW
POWER SUPPLY
12 To 30 VDC
DIGITAL CONTROL
Temperature
4-20mA return
+
–
–
ORANGE
ORANGE
Veris #PS-24
POWER SOURCE
12 to 24VAC/DC
DIGITAL CONTROL
Temperature
0-5/0-10V
-
-
Thermistor, RTD or Override
Setpoint
Veris PS-24 Series, or Panel
+
RIGHT
WIPER
LEFT
-
POWER SOURCE
12 to 24VDC Only
DIGITAL CONTROL
Temperature
4-20mA
-
-
Thermistor, RTD or Override
Setpoint
Veris PS-24 Series, or Panel
-
+
RIGHT
WIPER
LEFT
inStallation GUiDe
dImensIons
TDDA
TOA
TWxA
WIrIng - tdda and toa
TDDA/TOA – 4-20mA
TDDA/TOA – 0-5/0-10V
Z2 01986 -0 N PAGE 2 ©2010 Veris Industries USA 800.354.8556 or +1.503.598.4564 / support@veris.com 04101
Alta Labs, Enercep t, Enspector, Hawkeye, Trustat, Veris, and the Veris ‘ V’ logo are trademark s or registered tradema rks of Veris Industries, L.L .C. in the USA and/or othe r countries.
WIrIng - tWxa
TWxA – 4-20mA
TWxA – 0-5/0-10V
NOTE: For 24VAC transformer powered applications, one si de of transformer secondary is
connected to common. Isolation transfo rmer or dedicated power supply may be required.
Loading...