1. Read all instructions before using the Chocolate Fountain.
2. To protect against fire, risk of electrical shock, and personal injury,
do not immerse the Chocolate Fountain Base, its cord or plug, in
water or other liquid.
3. Close supervision is necessary when any appliance is used by or
near children.
4. Unplug from outlet when not in use, before putting on or taking
off parts, and before cleaning. Allow to cool before putting on or
taking off parts.
5. Avoid contacting moving parts.
6. Do not operate any appliance with a damaged cord or plug or
after the appliance malfunctions, or is dropped or damaged in any
manner. Contact Customer Service (see warranty) to return for
examination, repair or electrical or mechanical adjustment.
7. The use of attachments not recommended or sold by the
manufacturer may cause fire, electric shock or injury.
8. Do not use outdoors.
9. Do not let cord hang over edge of table or counter or touch hot
surfaces.
10. Do not touch hot surfaces. Use handles or knobs.
11. If any item drops into the Chocolate Fountain, turn control dial to
“OFF” and remove the power cord from the electrical outlet before
attempting to remove the item.
12. Do not place on or near a hot gas or electric burner, or in a heated
oven.
13. Extreme caution must be used when moving an appliance
containing hot oil or other hot liquids.
14. To disconnect, turn control dial to “OFF”, then remove plug from
wall outlet.
15. Do not use appliance for other than intended use.
-2-
16. Do not operate unless Chocolate Fountain is fully assembled.
Make sure the bowl, auger, tower, and canopies are properly
secured before operating appliance.
17. Only use the Chocolate Fountain on a smooth level surface.
SAVE THESE INSTRUCTIONS
This appliance is for HOUSHOLD USE ONLY.
No user-serviceable parts inside. Power unit never needs lubrication. Do
not attempt to service this product.
POLARIZED PLUG
This appliance has a polarized plug (one blade is wider than
the other). To reduce the risk of electric shock, this plug is
intended to fit into a polarized outlet only one way. If
the plug does not fit fully into the outlet, reverse the
plug. If it still does not fit, contact a qualified electrician.
Do not attempt to modify the plug in any way. If the plug fits loosely into
the AC outlet, or if the AC outlet feels warm, do not use that outlet.
AUTO SAFETY SHUT OFF
This Chocolate Fountain is equipped with an auto safety shutoff. Should
the motor become overheated, it will turn off. In order to restart the
Chocolate Fountain, follow the steps below.
1. Turn the control dial to OFF and unplug the Chocolate Fountain.
2. Remove the chocolate mixture from the bowl and place the mixture
into a microwave safe container.
3. Wait at least 20 minutes for the motor to cool.
4. Reheat the chocolate mixture in the microwave and add it back into
the bowl.
5. Plug in and operate normally.
-3-
KNOW YOUR RIVALTMCHOCOLATE FOUNTAIN
H
E
A
T
E
R
H
E
A
T
E
R
&
M
O
T
O
R
Drip Tray
Tower
Cap
Bowl
Control Knob
Base
Small Canopy
Large Canopy
Guard
Auger
BEFORE USING YOUR RIVALTMCHOCOLATE FOUNTAIN
Wash all parts according to the CLEANING YOUR RIVALTMCHOCOLATE
FOUNTAIN section in this manual.
Assembly
1. Insert the BOWL into the BASE and turn clockwise to lock into place.
2. Insert the AUGER into the BOWL.
3. Cover the AUGER with the TOWER.
4. Rotate the TOWER until it snaps twice and locks into position in the
BOWL.
5. Slide the GUARD down to the bottom of the TOWER.
6. Slide the LARGE CANOPY then the SMALL CANOPY down the
TOWER.
7. Place the CAP onto the top of the TOWER and align the tab on the
CAP with the groove in the top of the TOWER.
-4-
BEFORE USING YOUR RIVALTMCHOCOLATE FOUNTAIN (CONT.)
8. Assemble the DRIP TRAY by inserting the tabs into the opposite
opening and snap the two halves together. Slide the DRIP TRAY over
the TOWER and CANOPIES and rest it on the edge of the BOWL.
NOTE: Notches in DRIP TRAY should be facing upwards so skewers
can rest easily.
NOTE: All parts must be securely in place for the Chocolate Fountain to
properly operate. If the unit does not sit level, rotate the adjustable foot on
the bottom of the BASE until the unit is stable.
OPERATING YOUR RIVALTMCHOCOLATE FOUNTAIN
Operation with a Warm Mixture
Prepare the melted chocolate according to the instructions below:
1. Preheat the RivalTMChocolate Fountain for 3-5 minutes by
plugging the cord into a standard outlet and turning the
CONTROL KNOB to the HEATER setting.
IMPORTANT: DO NOT turn the CONTROL KNOB to
HEATER/MOTOR until the melted chocolate has been added to the
BOWL. Operating the Chocolate Fountain dry may cause damage
to the unit.
2. Add the melted chocolate to the BOWL and turn the CONTROL
KNOB to HEATER/MOTOR. Chocolate will start flowing up through
the TOWER and over the canopies to create a waterfall.
NOTE: The RivalTMChocolate Fountain must be on a level surface to flow
properly.
Operation with a Cool Mixture
1. Prepare the dressing or dip.
2. Add your mixture to the bowl and turn the control dial to
MOTOR. Your mixture will start flowing up through the TOWER
and over the canopies to create a waterfall.
NOTE: The RivalTMChocolate Fountain must be on a level surface to flow
properly.
-5-
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.