RIOTEC R8000 User Manual

R8000 module complies with Bluetooth2.0+EDR specification, with integrated

8Mbits flash and can be with specific application firmware. This module has
deployed CSR’s BC04-External chipset.

RF receiver, transmitter and synthesizer have been fully integrated into this
chipset. It supports pi/4 DQPSK and 8DPSK modulation to meet Bluetooth

2.0+EDR specification 2Mbps and 3Mbps data rate.

Balun filter is used for balanced RF port and to get a filtered single ended RF
port connected with antenna.

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY
NOT CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION.

Information for the OEMs and Integrators

The following stateme nt must be included with all vers ions of t his documen t suppli ed to an OE M or
integrator, but should not be distributed to the end us e r.
This device is intended for OEM integrators only. Please see the full Grant of Equipment
document for other restrictions. This device must be operated and used with a locally approved
access point.

Information To Be Supplied to the End User by the OEM or Integrator

The following regulatory and safety notices must be published in documentation supplied to the
end user of the product or system incorporating an adapter in compliance with local regulations.
Host system must be labeled with "Contains FCC ID: V3DR8000＂“, FCC ID displayed on the

label.

