*
Programming Quick Guide
-FS5027L
Installation
Make sure that the scanner has the correct cable to plug in the PC as
below described:
Barcode Configuration Method:
(Flow chart for setup procedure :)
Start
Configuration
End
Configuration
Keyboard Country (For USB HID only)
Scan the appropriate country code as below to program the keyboard
layout for your country or language. As a general rule, the following
characters are supported, but need special care for countries other
than the United States: @ | $ # { } [ ] = / ‘ \ < > ~
Belgium
Germany
Austria
Spain
Russia
Reset Configuration to Defaults
If you are unsure of the scanner configuration or have scanned the
incorrect codes, please scan from A1 to A3 for USB HID This will reset the
scanner to its factory defaults.
A1
A2
A3
Keyboard Country (For USB HID only)
Scan the appropriate country code as below to program the keyboard
layout for your country or language. As a general rule, the following
characters are supported, but need special care for countries other
than the United States: @ | $ # { } [ ] = / ‘ \ < > ~
USA
Denmark
France
Italy
Turkey F Turkey Q
Japan
Finland
UK
Norway
Sweden Portugal
1D Symbologies – 1
ENABLE
ENABLE
ENABLE
ENABLE
ENABLE
EAN-8
DISABLE
EAN-13 DISABLE
ISSN DISABLE
ISBN
DISABLE
Codabar DISABLE
1
If you want to read the Industrial 2 of 5 (3~5 digital),
Barcode Configuration Method:
(Flow chart for setup procedure :)
ENABLE
ENABLE
1D Symbologies – 3
GS1-Databar
(RSS)
UPC-E
DISABLE
DISABLE
please read the below setting code to set the Minimum
Length to 3 digits
1.
Start
Configuration
1D Symbologies – 2
ENABLE
ENABLE
ENABLE
ENABLE
Matrix
2 of 5
Industrial 25
Code 39
Code 93
End
Configuration
DISABLE
DISABLE
DISABLE
DISABLE
ENABLE
UPC-A
DISABLE
2.
ENABLE
ENABLE
Interleaved
2 of 5
Code 128
DISABLE
DISABLE
3.
4.
ENABLE
ENABLE
ENABLE
GS1-128
UCC/EAN-128
CODE 11
MSI
DISABLE
DISABLE
DISABLE
5.
6.
2
2D Symbologies
Data
ENABLE
ENABLE
ENABLE
ENABLE
Inter-Keystroke Delay
This parameter specifies the delay between emulated keystrokes.
No Delay
Matrix
QR Code
Micro
QR Code
PDF 417
DISABLE
DISABLE
DISABLE
DISABLE
(For USB HID Only)
Remark
:
When you have input error, you have to:
1. Try to change other keyboard as default
2. Deactivate spelling correct function & auto prediction
function
3. Change the Keystroke delay as 20ms or 40ms.
Short Delay
(20ms)
Long Delay
(40ms)
l Information in this document is subject to change without notice.
l For more information, please visit:
3
R_160511_03
Loading...