RIOTEC CR6327A, FS5027A Programming Quick Manual
Programming Quick Guide
-CR6327A. / FS5027A
Installation
Make sure that the scanner has the correct cable to plug in the PC as
below described:
*Note : Please install PL-2303 driver for USB serial
Auto-sensing setup
The auto-sensing will be activated while
scanner puts on stand. When scanner is
removed from stand, it becomes trigger
mode.
Reset Configuration to Defaults
If you are unsure of the scanner configuration or have scanned the incorrect
codes, please scan from A1 to A6 for USB HID or B1 to B6 for RS232 or USB
Serial. This will reset the scanner to its factory defaults.
USB HID RS232 or USB Serial
A1
B1
A2
B2
A3
B3
A4
B4
A5
B5
A6
B6
* Note: Please install PL-2303 driver for USB Serial.
Barcode Configuration Method:
(Flow chart for setup procedure :)
Start
Configuration
End
Configuration
Keyboard Country ( FOR USB HID Only)
Scan the appropriate country code below to program the keyboard for your
country or language. As a general rule, the following characters are not
supported by the scanner for countries other than the United States:
@ | $ # { } [ ] = / ‘ \ < > ~
USA
(Original setting)
Japan
Denmark
Finland
France
Germany
Italy Norway
1D Symbologies On/Off – 1
ENABLE
CODE 39
DISABLE
ENABLE
CODE 39 Transmit
Start/Stop Character
DISABLE
ENABLE
CODE 39
FULL ASCII
DISABLE
ENABLE
CODE 128
DISABLE
ENABLE
GS1-128
UCC/EAN-128
DISABLE
1
Barcode Configuration Method:
(Flow chart for setup procedure :)
Start
Configuration
End
Configuration
1D Symbologies On/Off – 2
ENABLE
Plessy DISABLE
ENABLE
MSI-
Plessey DISABLE
ENABLE
UPC-E DISABLE
ENABLE
UPC-A
DISABLE
1D Symbologies On/Off – 3
ENABLE
EAN-8
DISABLE
ENABLE
EAN-13
DISABLE
ENABLE
Interleaved
25 DISABLE
ENABLE
Matrix
25 DISABLE
ENABLE
Industrial 25 DISABLE
ENABLE
CODE 93 DISABLE
ENABLE
CODE 11 DISABLE
ENABLE
ISSN
DISABLE
ENABLE
ISBN DISABLE
1D Symbologies On/Off – 4
ENABLE
CODABAR
DISABLE
ENABLE
GS1-Databar
(RSS) DISABLE
ENABLE
GS1-Databar
(RSS-Limited) DISABLE
ENABLE
GS1-Databar
(RSS-Expand) DISABLE
Inter-Keystroke Delay( FOR USB HID Only)
This parameter specifies the delay between em ulated keystrokes
No Delay
Short Delay
(5ms)
Medium Delay
(10ms)
Long Delay
(15ms)
Information in this document is subject to change without notice.
For more information, please visit:
www.riotec.com.tw
R_140630_02
2
Loading...