RIOTEC DC9257A, DC9267A Programming Quick Manual

Up Side

Lower Side

1

5

2

6

3

7

4

Start

Configuration

End

Configuration

USA

Japan

Denmark

Finland

France

Germany

Italy

Norway

ENABLE

CODE 39

DISABLE

ENABLE

CODE 39 Transmit

Start/Stop Character

DISABLE

ENABLE

CODE 39

FULL ASCII

DISABLE

ENABLE

CODE 11

DISABLE

Trigger

Programming Quick Guide

-DC9257A: Docking Scanne r

-DC9267A: Wearable Scanner

Reset Configuration to Defaults

If you are unsure of the scanner configuration or have scanned the
incorrect codes, please scan the “Default” barcode. This will reset the
scanner to its factory defaults.

(scan from 1 to 7)

Keyboard Language (For USB HID only)

Scan the appropriate country code as below to program the keyboard
layout for your country or language. As a general rule, the fo llowing
characters are supported, but nee d special care for countries other
than the United States: @ | $ # { } [ ] = / ‘ \ < > ~

Docking Scanner:

Gently tap the trigger area at the middle o f sc anne r , to e nable the
scanner (for reading barcode)

Wearable Scanner:

Press the ring trigger to enable the scanner.

Barcode Configuration Method:

(Flow chart for setup procedure :)

Area

(Original setting)

1D Symbologies – 1

The touch sensor area is around mid dle of the scanner as drawing shown.

Installation

They are Plug &Play USB (HID) devices. When plugged into your Andro id
OTG devices, it can be recognized as barcode scanner and begin to scan
the barcode. Before using scanner, make sure the smartphone or tablet
is fully charged. Open your APP, they can work as a keyboard input.

1

Start

Configuration

End

Configuration

ENABLE

DISABLE

ENABLE

DISABLE

ENABLE

DISABLE

ENABLE

DISABLE

ENABLE

DISABLE

ENABLE

Interleaved

25

DISABLE

ENABLE

Matrix

DISABLE

ENABLE

DISABLE

ENABLE

DISABLE

ENABLE

DISABLE

ENABLE

DISABLE

ENABLE

GS1-128

UCC/EAN-128

DISABLE

ENABLE

GS1-Databar

DISABLE

ENABLE

GS1-Databar

DISABLE

ENABLE

GS1-Databar

DISABLE

ENABLE

DISABLE

ENABLE

DISABLE

Short Delay

(5ms)

Information in this document is subject to change without notice.

R_151117_01

Barcode Configuration Method:

(Flow chart for setup procedure :)

1D Symbologies – 3

UPC-A

1D Symbologies – 4

(RSS-Limited)

(RSS-Expand)

25

ISSN

Industrial 25

1D Symbologies – 2

MSI

EAN-8

CODE 93

CODABAR

CODE 128

Inter-Keystroke Delay (FOR USB HID Only)

This parameter specifies the delay between emulated keystrokes

No Delay

Medium Delay

(10ms)

EAN-13

UPC-E

(RSS)

ISBN

Long Delay

(15ms)



2