RIOTEC CR6300C, FS5020C, CR6320C Programming Quick Manual
Programming Quick Guide
CR6300C/CR6320C/FS5020C
Installation
Make sure that the scanner has the correct cable to plug
into the PC as below described:
1. USB cable connection
(Please use correct cable for the interface)
Reset Configuration to Default
If you are unsure of the scanner configuration or have
scanned the incorrect codes, please read the “Default”
barcode. This will reset the scanner to its factory default.
1.
0B
2.
01802
HID Default
2. Auto-sensing setup
The auto-sensing will be activated while scanner puts on
stand. When scanner is removed from stand, it becomes
trigger mode.
OUTPUT MODE -
KEYBOARD / USB
OUTPUT
MODE
OUTPUT MODE
- RS232 (SERIAL)
SINGLE SCAN
READING
MODE
SINGLE SCAN
NO TRIGGER
Demo
LASER TIMEOUT
- 5 SECONDS
LASER TIMEOUT
- 2 SECONDS
Keyboard Language
Scan the appropriate country code as below to program the keyboard layout
for your country or language. As a general rule, the following characters are
supported, but need special care for countries other than the United States:
@ | $ # { } [ ] = / ‘ \ < > ~
USA
FINLAND
FRANCE
GERMANY
ITALY
PORTUGAL
NETHERLANDS
NORWAY
BELGIUM
SPAIN
SWITZERLAND
RUSSIAN
SWEDEN
CZECH
CANADA
DENMARK
GREECE
HUNGARY
JAPAN
ENGLAND
TURKEY1
TURKEY2
Symbologies -1
CODE 11
- ENABLE
CODE 11
CODE 11
- DISABLE
www.tec-it.com
CODE 39
- ENABLE
CODE 39
CODE 39
- DISABLE
Demo
Demo
FULL ASCII
- ENABLE
FULL ASCII
- DISABLE
Demo
CODE 93
- ENABLE
CODE 93
CODE 93
- DISABLE
Demo
Demo
CODE 128
- ENABLE
CODE 128
CODE 128
- DISABLE
Demo
Demo
CODE 128 ISBT
- ENABLE
CODE 128 ISBT
- DISABLE
Demo
CODABAR
- ENABLE
CODABAR
CODABAR
-DISABLE
Demo
Symbologies -2
I2OF5
- ENABLE
INTERLEAVED
2 OF 5
I2OF5
- DISABLE
ID2OF5
-ENABLE
INDUSTRIAL
2 OF 5
ID2OF5
- DISABLE
Demo
MSI
- ENABLE
MSI
MSI
- DISABLE
Demo
UPC-A
- ENABLE
UPC/EAN
UPC-A
-DISABLE
Demo
Demo
UPC-E -ENABLE
UPC-E
-DISABLE
Demo
EAN-13
-ENABLE
EAN-13
-DISABLE
EAN-8
- ENABLE
EAN-8
-DISABLE
Demo
www.tec-it.com
Information in this document is subject to change without notice.
For more information, please visit:
www.riotec.com.tw
R_20180530_01
Loading...