EX11C (RHFE-265FTA)
Type of Appliance
Rinnai Model Number
Gas Rate Input (BTU/hour)
Gas Rate Output (BTU/hour)
AFUE Rating
Minimum Gas Supply Pressure
Maximum Gas Supply Pressure
Electrical Connection
Gas Connection
Combustion System
Ignition System
Fan CFM Output
Temperature Settings
Temperature Control
Direct vent wall furnace suitable for homes, apartments, and
condominiums, residential or commercial setting; modular/mobile home
approved; forced combustion, forced convection
RHFE-265FTA-A-N (Natural gas) RHFE-265FTA-A-P (Propane)
Low - 5,500 Low - 5,700
High - 11,000 High - 11,000
Low - 4,400 Low - 4,560
High - 8,800 High - 8,800
81% 82%
3.5 in (89 mm) W.C. 8 in (203 mm) W.C.
10.5 in (267 mm) W.C 13 in (330 mm) W.C.
AC 120V, 60 Hz, 44 watts
1/2 inch NPT
Stainless steel Bunsen burners
Electronic spark ignition
Low - 96.4 High - 128.5
Low (LO): minimum combustion
60° - 80° F in 2° increments
High (HI): maximum combustion
• Electronic thermostat
• Temperature limiting program to comply with Inside Design
Temperature limits
Humidifier Tray
Weight
Clearance from Combustibles
Noise Level
Warm Air Outlet
FEATURES
Restart capability:
Timer Settings:
Seven-stage modulating gas valve:
Negative coefficient thermistor:
Variable speed inducer motor with
pressure switch:
Self diagnostic electronics:
Quiet operation:
© 2010 Rinnai Corporation
Enameled tray with capacity of 1.5 pints (700 cc)
Approximately 46 lbs (21 kg)
Side: 2 inches (50 mm), Top: 0 inches (0 mm), Front: 40 inches (1 m)
31 - 38 dB(A)
Bottom front louvers
restarts automatically when ignition or combustion fails
starts and turns off the heater at 2 timer settings
provides precise gas flow by operating from one to seven stages
detects temperature change in 1/2 of a degree
monitors and controls combustion fan and allows the appliance to
overcome winds of up to 40 mph
continually monitors functions; provides auto shutdown codes; indicates
when air filter needs cleaning
reduces noise through use of swept blades in convection fan; quiet
expansion / contraction of parts due to temperature changes
RHFE-265FTA SP 6/2010
EX11C (RHFE-265FTA)
Safety Devices
Venting
Maximum Vent Length
Wall Thickness and
Flue Manifold Kits
(the “A” vent kit is included
with the appliance)
Warranty
• Flame rod detects flame failure; results in auto shutdown to prevent escape
of gas
• Bi-metal switch, thermal fuse, and thermistor detect overheat condition;
results in auto shutdown
• 3 amp fuse protects against power surge; results in auto shutdown
• Abnormal spark at time of ignition results in auto shutdown
• Combustion fan purges any gas from the combustion chamber before
ignition
• Convection fan continues to run after burner shutdown to cool internal parts
• Child lock prevents inadvertent operation
• Appliance shuts down if room reaches 104° F (40° C)
concentric; 3 1/8 inch (80 mm) wall hole
13 feet (4 m) with a maximum of 2 bends;
maximum 8 ft (2.4 m) vertically for altitudes at or below 2000 ft (610 m)
maximum 5 ft (1.5 m) vertically for altitudes above 200 ft (610 m)
Name Kit No. fits walls
S Vent Kit FOT-150 3 - 4 1/2 in (75 - 115 mm)
A Vent Kit FOT-151 4 1/2 - 9 1/2 in (115 - 240 mm)
B Vent Kit FOT-152 9 1/2 - 15 3/4 in (240 - 400mm)
C Vent Kit FOT-153 15 3/4 - 23 5/ 8 in (400 - 600 mm)
D Vent Kit FOT-154 23 5/8 - 31 1/ 2 in (600 - 800 mm)
Labor: 2 years; Parts: 5 years; Heat Exchanger: 10 years
Conversion Kit
Rinnai is continually updating and improving products; therefore, specifications are subject to change without prior
notice. Local, state, provincial and federal codes must be adhered to prior to installation.
DIMENSIONS
Rinnai Corporation • 103 International Drive • Peachtree City, GA 30269 • Toll-Free: 1-800-621-9419 • Fax: 678-829-1666 • www.rinnai.us
27.375 in
(695 mm)
To natural gas: 204000034 To propane gas: 204000038
18.25 in (465 mm)
24.44 in
(88 mm)
24.375 in
(620 mm)
10.1 in (257 mm)
6.8 in (172 mm)
Wall
Bracket
3.3 in
(85 mm)