Keypad Z-Wave
Technical Manual
1
Ring Keypad
Adding Keypad to a Z-Wave Network
Ring Keypad can be added via smart start or via classic inclusion mode –
Smart Start Inclusion Steps:
1. Initiate add keypad flow in the Ring Alarm mobile application – Follow the guided add flow
instructions provided in the application
2. Scan the QR code found on the package of the keypad or the QR code found on the back
of the keypad
3. Plug in the keypad to line power
4. When the inclusion process in complete, the LED on the keypad will be solid blue, then go out.
5. Test the Keypad. Any button presses would beep
Classic Inclusion Steps:
1. Initiate add keypad flow in the Ring Alarm mobile application – Follow the guided add flow
instructions provided in the application
2. Select add manually and enter the 5 digit DSK pin found on the package of the keypad or the
QR code found on the back of the keypad
3. Plug in the keypad to line power
4. Press and hold “1” key for three seconds
5. When the inclusion process in complete, the LED on the keypad will be solid blue, then go out.
6. Test the Keypad. Any button presses would beep
2
Removing a Keypad to a Z-Wave Network
Exclusion Instructions
1. Initiate remove keypad flow in the Ring Alarm mobile application – Select the settings icon from
device details page and choose
“Remove Device”
2. Press and hold “1” key for three seconds
3. When the exclusion process in complete, the LED on the keypad will be solid blue, then go out.
4. Test the Keypad. Any button presses would not beep
Ring Base station – Lifeline
Association
This keypad has one Association group with 1 node. Group 1 is a lifeline group who will receive
unsolicited messages relating to entry control notifications, notifications reports, battery report
notifications, and device reset locally notifications
Ring Base Station – Reset
Factory Default Instructions
1. Press and hold “5” key and using a pointed end of a paperclip, gently press and release
reset button via the reset pin hole found at the back of the keypad
2. Red network LED at the top left-hand corner will start to blink rapidly
3. Wait for the red LED to stop blinking then release the “5” key
Use this procedure only in the event that the network primary controller is missing or otherwise
inoperable.
To review your warranty coverage, please visit www.ring.com/warranty.
© 2020 Ring LLC or its affiliates.
Ring, Always Home, and all related logos are trademarks of Ring LLC or its affiliates.
3
Loading...