Installation Guide RIGOL
RIGOL
Rack Mount Kit
MSO4000/DS4000
This rack mount kit is designed to mount RIGOL MSO4000/DS4000 series digital
oscilloscope into a 19-inch cabinet that conforms to the Electronic Industries Association
(EIA) standard.
Kit Part Checklist
No. Name Qty. Description
1 Front Plate 1 -2 Right Plate 1 -3 Left Plate 1 -4 M4 Screw 4 M4x8 Phillips Pan Head Screw
5 M6 Screw 6 M6x16 Phillips Pan Head Screw
6 M6 Nut 6 M6 Square Lock Cage Nut
1 2 3
Installation Tool
The PH2 Philips screwdriver is recommended.
4 5 6
1
Installation Guide RIGOL
Space Requirements
To mount the instrument into the cabinet correctly, please ensure that the following
requirements are met.
The cabinet must be a standard 19-inch one.
The available height of the cabinet should be at least 6U (266.7 mm).
The depth of the cabinet should be at least 400 mm.
The dimensions of the rack are as shown below.
Installation Procedures
CAUTION
Only authorized operators are allowed to perform the installation. Improper
installation might cause damage to the instrument or an installation failure.
Unit: mm
2
Installation Guide RIGOL
1． Install the left plate: Attach the left plate to the left edge of the front plate, then fasten
them with two M4 screws.
2． Place the instrument: Place the instrument into the frame set up by the front plate and
the left plate.
3
Installation Guide RIGOL
Space Requirements
To mount the instrument into the cabinet correctly, please ensure that the following
requirements are met.
The cabinet must be a standard 19-inch one.
The available height of the cabinet should be at least 6U (266.7 mm).
The depth of the cabinet should be at least 400 mm.
The dimensions of the rack are as shown below.
Installation Procedures
CAUTION
Only authorized operators are allowed to perform the installation. Improper
installation might cause damage to the instrument or an installation failure.
Unit: mm
2
Loading...